Rear Panel Connectors - Seagate Barracuda 7200.12 User Manual

NVS User's Manual
2.3

Rear Panel Connectors

There are various connectors on the rear panel for the NVS installations. The
connectors are described as the following.
Power Jack
Connect the power supply cord shipped with the NVS.
e-SATA (Reserved)
Users can connect an e-SATA storage device via this
port to expend HDD capacity of the NVS.
Uplink
Connect to a LAN port via a RJ-45 cable and the NVS
are connected to the Ethernet. Then users can connect
to the NVS via the internet browser.
LED Indication
Each IP camera has two corresponding LEDs:
1. The lightened orange LEDs represent the IP camera
is connected and power is supplied via PoE. When a
LED is off, either the IP camera is not connected or
its power supply is separately connected.
2. The
transmission goes from the IP cameras to the NVS.
When a LED is not on, that means the IP camera is
not connected.
RJ-45 PoE
The NVS provides RJ-45 ports that support
Power over Ethernet (PoE). IP cameras can
be connected via just one Ethernet cable,
without the need of power cable connection.
8
NOTE: Use of other power supply cords may
cause overloading.
blinking green LEDs represent data