Page 1
DuraGlide ™ Anodized Iron Instruction Booklet KI820...
Page 2
In the event that you need some assistance with your Kambrook appliance, please contact our Customer Service Department on 1300 139 798 (Australia) or 09 271 3980 (New Zealand). Alternatively, visit us on our website at...
Contents Kambrook Recommends Safety First p4 Your Kambrook DuraGlide Anodized Iron Operating Instructions How to Use Shot of Steam Care and Cleaning Warranty Details ™...
IMPORTANT: Please retain your instruction book for future use. At Kambrook, we believe that safe performance is the first priority in any consumer product, so that you, our valued customer can confidently use and trust our products. We ask that any electrical appliance that you use be operated in a sensible fashion with due care and attention placed on the following important operating instructions.
• Do not use outdoors or in bathrooms. • Do not store the iron with water in the water tank. Always empty the tank after use. Ensure the iron is cool before storing or wrapping the cord around the storage heel facility.
Your Kambrook DuraGlide Auto-off for safety protection: The iron automatically switches off when left unattended. Auto- off light will illuminate when auto- off function is active Fine mist spray button: Helps removal of creases Shot of steam button: For an...
Remove any promotional material or packaging from the iron. Remove any sticker or protective cover from the soleplate. When operating the iron for the first time, iron on an old piece of fabric to ensure that the soleplate and water tank are completely clean.
Set the Temperature Control to the required position within the steam range and wait until the Heating Indicator Light has gone out. Set the Steam Control (on top of the handle) to the required setting. Your Kambrook iron is now ready for use.
Page 9
IMpORTANT: If the iron is set to a low temperature on the temperature control (i.e. Synthetic or Silk) and also on any of the steam control settings, there may be leakage from the soleplate. This is due to the iron temperature not...
Once the temperature has been reached the heat indicator light will turn off and the iron is ready for use. Using the Fine Mist Spray The fine mist spray can be used to dampen difficult fabrics, dry areas, woollen items and accidental creases.
Anti Drip System The Kambrook DuraGlide™ Anodized Iron is equipped with an Anti-Drip System. The iron will automatically close the steam valve when the soleplate temperature is too low to produce steam. When this happens you will hear a click sound. It is safe and will not harm the performance of the iron.
Page 12
• Open the water filling cap and (over a sink or bucket) invert the iron to empty the remaining water from the tank. • Stand the iron in an upright position and allow to cool.
• Set the Temperature Control to MAX (Linen) setting. • Place the iron in the upright position, insert the plug into the power outlet and switch the iron on. • Allow the iron to heat until the Heating Indicator Light turns off.
Page 16
Act 1993 in relation to the appliance. It applies in addition to the conditions and guarantees implied by that legislation. This Kambrook Replacement Warranty is valid only in the country of purchase, but other statutory warranties may still apply. This Warranty card and the purchase receipt for this...
Need help?
Do you have a question about the DURAGLIDE KI820 and is the answer not in the manual?
Questions and answers