Kohler XT-6 Service Manual page 6

Specifications
TORQUE SPECIFICATIONS
Connecting Rod
Cap Fastener (torque in increments)
Crankcase
Oil Drain Plug
7
Oil Pan Screw
Cylinder Head
Fastener (torque in 2 increments)
Flywheel
Retaining Nut
Fuel Tank
Bracket to Crankcase Stud
Bracket to Tank Fastener
Governor
Lever Fastener
Gear Fastener
Ignition
Spark Plug
Module Fastener
Screw
Muffler
Exhaust Stud
Exhaust Stud Nut Fastener
Retractable Starter
Fastener
Rocker Arm
Stud
Pivot Jam Nut
Speed Control
Bracket Assembly Fastener
Valve Cover
Fastener
Values are in Metric units. Values in parentheses are English equivalents.
3
Lubricate threads with engine oil prior to assembly.
5
Apply thread sealant around three full threads before assembly. No excess sealant allowed on inside or outside of
7
joint. Threads with preapplied sealant do not require use of additional sealant. Approved sealants include Perma-Loc
LH 150, Perma-Loc MM 115, Perma-Loc HH 120, Perma-Loc HL 126.
6
3,5
KohlerEngines.com
XT-6, XTR-6
XT6.5, XT650,
XT6.75, XT675
12.5 N·m (110 in. lb.)
13.6 N·m (120 in. lb.)
11.0 N·m (98 in. lb.) 14.7 N·m (130 in. lb.)
first to 14 N·m (123 in. lb.)
finally to 27.8 N·m (246 in. lb.)
51.5 N·m (38 ft. lb.)
8 N·m (71 in. lb.)
4.5 N·m (40 in. lb.)
9.5 N·m (84 in. lb.)
9.5 N·m (84 in. lb.)
27 N·m (20 ft. lb.)
10 N·m (88 in. lb.)
10 N·m (88 in. lb.)
5.0 N·m (44 in. lb.)
9.5 N·m (84 in. lb.)
8 N·m (71 in. lb.)
13.6 N·m (120 in. lb.)
9.5 N·m (84 in. lb.)
8 N·m (71 in. lb.)
8 N·m (71 in. lb.)
XT-7, XTR-7,
XT775, XT8
14 690 01 Rev. G