Troubleshooting - Dish TV satBox-ultra User Manual

Troubleshooting

Problem
No picture
Remote control is not
working
When recording 1 channel
cannot go to another
channel
Picture is distorted -
too wide or narrow
No Channels loaded.
Database is Empty
24
Possible Causes
S7090PVR is not plugged in or turned
on at the wall.
Your display isn't able to display the
current Output Format.
No batteries or batteries incorrectly
inserted.
Batteries are flat.
Infrared reciever on S7090PVR is
obstructed.
No Signal to Tuner.
Wrong TV shape is set.
No Signal In.
Faulty LNB or Dish.
Solution
Check the front panel. If nothing
is illuminated then it is a power
issue - please check power
socket and plug socket.
Please make sure that Main Menu -
Installation - System Setting - HD
Resolution is set to one that
your TV will be able to display.
You can view this using the
composite output
Insert the supplied 2x AAA batteries
as shown on page 6.
Insert fresh batteries as shown on
page 6.
Check that there is a clear "line of
sight" from the remote to the sensor
on the front panel.
Fit loop cable from LNB1 Out to
LNB 2 In
Go to Main Menu/Installation/System
Setting/Aspect Ratio, make sure it is
set to match the shape of your display.
Dish Cable not plugged into LNB in
Have dish checked then try Main
Menu/Installation/Factory Default
and scan again.