Advertisement
Using Your Ceramic Heater
Before First Use
Remove any promotional material or
packaging from the heater.
Unwind the cord to its full length
and place the heater on a firm, level
surface in a stable upright position.
Visually inspect the air inlet and outlets
to ensure there are no blockages.
Turning Your Heater On
Plug the cord into a 230V or 240V
power point and switch on.
NOTE: To avoid an electrical
circuit overload, it is
recommended that no other
appliances are plugged into
the same circuit as your heater,
when it is in use.
Turn the heater on by switching the
On/Off
switch located on the
left hand side of the base, to the on
position. An audible beep will sound,
and the red power indicator light
will illuminate. The heater is now in
standby mode.
Setting the Heating Mode
8
To activate the heater, press the
POWER/SWING
will start operating on the LOW heat
setting (1100 watts) and the LCD
screen will illuminate, displaying the
ambient room temperature and heat
setting.
NOTE: After several seconds,
the LCD screen will fade, but
the heater settings will remain
visible.
Use the MODE
button to select the
desired heat setting. The mode button
allows you to scroll through the various
heating modes.
HIGH – High heat setting (1800 watts)
LOW – Low heat setting (1100 watts)
AUTO – for use with the electronic
thermostat
FAN – for fan only operation
To switch the heater into standby
mode, press and hold the POWER/
SWING
button until a beep sound
is heard.
Turn the heater off by switching the
Power
switch located on the right
hand side of the base, to the off
position.
NOTE: This heater features a
tip-over switch. If the heater
tips over, it will automatically
switch off. Once placed back
into the upright position, the
heater will be in standby mode,
and the settings will need to be
selected again.
button. The heater
Advertisement
