Advertisement
5.
To turn the heater off, the 'O' setting
needs to be selected. This will turn the
heater off, and the power indicator light
will go out.
NOtE: there is a tip over switch
fitted
to
this
the
heater
automatically turn off. the heater
will need to be placed back into
the upright position and the start
sequence and desired temperature
settings selected again.
tHERmO gUaRD
OvERHEatINg SafEtY
DEvICE
Your heater is fitted with a safety device
that switches off the heater in the event
of overheating. Should this heater stop
working, turn off the heater and inspect
for blockages in air inlet or outlets. Wait
at least five minutes for the protection
system to reset before attempting to
restart the heater.
If the heater fails to operate or the
safety device switches off again, return
the heater to your nearest service
centre for examination or repair.
CaRE aND maINtENaNCE
•
Always turn off and then unplug the
heater before cleaning.
•
Use only a clean, dry cloth to clean the
external surfaces of the heater only.
•
If the heater has collected dust or dirt
inside the unit or around the elements,
have the unit cleaned by a qualified
service agent. Do not operate the heater
in this condition.
•
Do not attempt to open the case of the
heater.
When
tips
over
it
heater at any time there are no customer
serviceable parts inside.
•
When not in use, pack the heater,
preferably in its original box for best
protection and store in a cool, clean and
dry location.
will
•
The air filter at the rear of the heater
can be easily cleaned by removing the
filter casing panel and removing the
mesh filter. A basic clean in warm water
to remove any build up is adequate and
allow time to completely dry before
replacing the filter and the filter casing
panel.
Advertisement
