Front Brake Disc - PIAGGIO B 250 Workshop Manual

B 125-250
- Remove the wheel and check using the appro-
priate tools that the axial run-out of the brake
surface is within the prescribed limits.
- If this is not the case, replace the disc and repeat
the test.
WHEN INSTALLING, THOROUGHLY CLEAN THE DISC
AND ITS SEAT ON THE HUB.
Characteristic
Max. axial run-out
0.1 mm

Front brake disc

Removal
Proceed as follows:
- Remove the front wheel.
- Loosen the five disc fixing screws.
- Thoroughly clean the seats on the front wheel
hub and on the disc.
See also
Removing the front wheel
Refitting
For fitting, position the disc correctly using the arrow stamped on it as reference.
- Do up the screws to the prescribed torque and apply the recommended product
N.B.
THE ARROW STAMPED ON THE DISC INDICATING THE RUNNING DIRECTION MUST BE FITTED
TOWARDS THE OUTSIDE OF THE VEHICLE.
Recommended products
Loctite 243 Medium strength threadlock
Loctite 243 medium-strength threadlock
Locking torques (N*m)
Brake disc fixing screw 5 ÷ 6.5
Braking system
BRAK SYS - 245