Toyota HIGHLANDER 2014 Warranty & Maintenance Manual page 44

Maintenance Log
35,000 miles or 42 months
Check installation of driver's floor mat
Inspect and adjust all fluid levels
Inspect wiper blades
Rotate tires
Visually inspect brake linings/drums and
brake pads/discs
Note: If 0W-20 oil WAS NOT used at
the last oil change, replace engine oil
1
and oil filter.
Additional Maintenance Items for
Special Operating Conditions
Driving on dirt roads or dusty roads:
Inspect ball joints and dust covers
Inspect drive shaft boots
Inspect engine air filter
Inspect steering linkage and boots
Re-torque propeller shaft bolt (4WD)
Replace engine oil and oil filter
Tighten nuts and bolts on chassis and
body
Driving while towing, using a car-top
carrier, or heavy vehicle loading
Re-torque propeller shaft bolt (4WD)
Replace engine oil and oil filter
Tighten nuts and bolts on chassis and
body
Repeated trips of less than five miles in
temperatures below 32°F / 0°C:
Replace engine oil and oil filter
Extensive idling and/or low speed driving
for a long distance such as police, taxi or
door-to-door delivery use:
Replace engine oil and oil filter
D S V
EALER ERVICE ERIFICATION
D :
ATE
M :
ILEAGE
42
Maintenance Log
2
3
1
5
:
3
1
1
1
:
40,000 miles or 48 months
Check installation of driver's floor mat
Inspect and adjust all fluid levels
Inspect wiper blades
Replace engine oil and oil filter
Rotate tires
Visually inspect brake linings/drums and
brake pads/discs
Additional Maintenance Items for
Special Operating Conditions
Driving on dirt roads or dusty roads:
Inspect ball joints and dust covers
Inspect drive shaft boots
Inspect engine air filter
Inspect steering linkage and boots
Re-torque propeller shaft bolt (4WD)
Tighten nuts and bolts on chassis and
body
Driving while towing, using a car-top
carrier, or heavy vehicle loading
Re-torque propeller shaft bolt (4WD)
Tighten nuts and bolts on chassis and
body
D S V
EALER ERVICE ERIFICATION
D :
ATE
M :
ILEAGE
1
2
3
5
:
3
: