Batteries; Installation - Kirk DELTA S1 User Manual

1.1 Batteries

To use all the functions in the DELTA telephone you have to insert the enclosed
batteries of the type LR06 (AA).
When it is time to change the batteries, the
During normal use the last for about 1 år.
To ensure that the settings will remain in the subset during change of battery it is
necessary to put the subset into a stop mode.
1. Remove the telephone from the line.
2. Press the
3. Press the * - key. The
4. Press the
stop mode.
5. Now you have approximately 30 seconds to change the batteries.
6. Press and hold the
the clock.
7. Reprogram the clock, see chapter 1.4.
Warning! The telephone has to be disconnected from the telephone line before the
battery cover is removed.
Note! Do not dispose of batteries with normal household trash. They must be
disposed of in accordance with applicable waste disposal regulations.

1.2 Installation

1. Insert the batteries as showed on the figure.
2. Connect the coiled cord from the handset to the lower connector on
the left side of the telephone. When the connector is properly fixed
you will hear a click sound.
3. Connect the line cord to the upper connector on the left side of the
telephone. When the connector is properly fixed you will hear a
click sound.
4. Inset the other end of the line cord into the wall plug.
5. Remove the handset from the cradle. If you can hear the dial tone
the subset is ready for use else please look into chapter 8;
Troubleshooting.
- symbol in the display is turned on.
- key.
- symbol in the display is turned on.
- key, the display show -------- and the subset enter
- key for 3 seconds until the display shows
6