Controls And Indicators - Dell OptiPlex GX1 Installation Manual

Controls and Indicators

Reset control
Power control
Power indicators
Hard-disk drive access indicator
Link integrity indicator
(on optional integrated NIC connector)
Activity indicator (on optional integrated NIC
connector)
Power
DC power supply:
Wattage
Heat dissipation
Voltage
Backup battery
Physical
Height
Width
Depth
Weight
Environmental
Temperature:
Operating
Storage
Relative humidity
Maximum vibration:
Operating
Storage
Maximum shock:
Operating
Storage
Altitude:
Operating
Storage
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online System User's Guide.
push button
push button
green LEDs (one on front panel, one on riser board); blinking green in sleep state
green LED
green LED
yellow LED
200 W
913 BTUs (fully loaded system without monitor)
90 to 135 V at 60 Hz; 180 to 265 V at 50 Hz
3-V CR2032 coin cell
16.5 cm (6.5 inches)
41.9 cm (16.5 inches)
44.5 cm (17.5 inches)
12.7 kg (28.0 lb) or more, depending on options installed
10 to 35C (50 to 95F)
-40 to 65C (-40 to 149F)
8% to 80% (noncondensing)
0.25 G at 3 to 200 Hz at 1 octave/min
0.5 G at 3 to 200 Hz at 1 octave/min
left side (vertical orientation) and bottom half-sine pulse with a change in velocity of 20
inches/sec (50.8 cm/sec)
27-G faired square wave with a velocity change of 200 inches/sec (508 cm/sec)
-16 to 3048 m (-50 to 10,000 ft)
-16 to 10,600 m (-50 to 35,000 ft)