Dell OptiPlex GX1 Installation Manual page 49

Minimum
Wakeup On LAN
Wakeup On LAN determines whether the Wakeup On LAN feature is set to On or Off. You must reboot your system before a change takes effect.
Sound
Sound determines whether the integrated audio controller is On or Off. You must reboot your system before a change takes effect.
NIC
NIC determines whether an integrated network interface controller (NIC) is On or Off. You must reboot your system before a change takes effect.
Mouse
Mouse enables or disables the system's built-in PS/2-compatible mouse port. Disabling the mouse allows an expansion card to use interrupt
request (IRQ) 12.
For more information about built-in ports, port designations, IRQs, and the remapping of ports, see "Connecting External Devices" in your online
System User's Guide.
Serial Port 1 and Serial Port 2
Serial Port 1 and Serial Port 2 configure the system's built-in serial ports. These options can be set to Auto (the default) to automatically configure
a port, to a particular designation (COM1 or COM3 for Serial Port 1; COM2 or COM4 for Serial Port 2), or to Off to disable the port.
If you set a serial port to Auto and add an expansion card containing a port configured to the same designation, the system automatically remaps
the built-in port to the next available port designation that shares the same IRQ setting as follows:
COM1 (input/output [I/O] address 3F8h), which shares IRQ4 with COM3, is remapped to COM3 (I/O address 3E8h).
l
Likewise, COM2 (I/O address 2F8h), which shares IRQ3 with COM4, is remapped to COM4 (I/O address 2E8h).
l
NOTES: When two COM ports share an IRQ setting, you can use either port as necessary, but you may not be able to use them both
at the same time. If the second port (COM3 or COM4) is also in use, the built-in port is turned off.
If you are using the Microsoft Windows 95 or IBM OS/2 operating system, you cannot use both serial ports at the same time.
For more information about built-in ports, port designations, IRQs, and the remapping of ports, see "Connecting External Devices" in your online
System User's Guide.
Parallel Port
Parallel Port configures the system's built-in parallel port. This option can be set to 378h (the default), to alternate addresses 278h or 3BCh, or to
Off to disable the port.
NOTE: Do not set Parallel Port to 278h if you have an Enhanced Capabilities Port (ECP) device connected to the port.
Parallel Mode
Parallel Mode controls whether the system's built-in parallel port acts as an AT-compatible (unidirectional) or PS/2-compatible (bidirectional) port.
Your system also supports ECP mode, which can be used by Windows 95 and Windows 98. Windows 95 and Windows 98 use ECP protocol
automatically if the operating system detects an ECP-capable device, eliminating the need for an ECP setting in this option.
Set this option according to the type of peripheral device connected to the parallel port. To determine the correct mode to use, see the
documentation that came with the device.
IDE Hard Disk
IDE Hard Disk enables or disables the system's built-in EIDE hard-disk drive interface.
With Auto (the default) selected, the system turns off the built-in EIDE interface when necessary to accommodate a controller card installed in an
expansion slot.
As part of the boot routine, the system first checks for a primary hard-disk drive controller card installed in an expansion slot. If no card is found, the
system enables the built-in EIDE interface to use IRQ14 and IRQ15.
If a primary controller is detected on the expansion bus, the built-in EIDE interface is disabled.
Selecting Off disables the built-in EIDE interface.
Diskette
20 minutes 1 hour Never