Operation - Carter INTERCEPTOR GTR 250 Owner's Manual

A. Operation Controls
WARNING - Do not attempt to start or operate the engine until you are completely familiar
with the location and use of each control necessary to operate this vehicle. The operator must
know how to stop this machine before starting and driving it.
a. Throttle
The right foot pedal is the throttle that controls the kart speed. As the engine speed
increases above idle, the clutch automatically engages and moves the vehicle forward. To
disengage the clutch at any time, allow the throttle to return to the idle position.
Each time prior to start the engine, check the throttle assembly to ensure
that when the pedal is pushed all the way forward the assembly is working
smoothly and returns to idle when released. Do not operate if pedal or engine throttle
linkage fail to return to idle. If unable to correct the problem through lubrication,
adjustment, or replacement of worn parts, contact your dealer for assistance.
b. Brake
The brake is located on the left side of the kart. Applying pressure to the
pedal draws the brake caliper around the brake pump at the rear wheel and slows or stops
the kart.
c. Start engine.
Insert the key into key-switch, turn the
key clockwise, release the key when
the engine starts. Kart must be in neutral.
The engine will warm up within 5 minutes
if the engine is cold you will need to pull
the choke lever under the seat.
(Warning: Don't crank starter more
than 5 seconds at one time).
e. Engine stop button.
IMPORTANT STOP BUTTON TEST
Before driving this vehicle, test the engine
stop button to assure that it is operating properly. With the engine running, push and hold the
engine stop button for two seconds for the engine to shut down.

OPERATION

WARNING
ENGINE STOP BUTTON
BRAKE
20
KEY SWITCH
THROTTLE