Controlling The Wheelchair Using The Remote - Invacare Tornado Operating Instructions Manual

7.6

Controlling the wheelchair using the remote

• Switch on the remote (ON/OFF button). The displays on the remote will illuminate. The
wheelchair is ready to drive.
• Set the drive level ("drive level" button see "Layout of the remote" on page 38).
• Speed stage 1 (slow) to 5 (fast) is shown on the drive level display.
Can the electronic system programming be adapted?
The electronic controller is programmed with standard values during manufacture. Your
Invacare® dealer can carry out programming tailored to fit your requirements.
WARNING: Any alteration to the drive programme can influence vehicle handling and the
tipping stability of the electric vehicle!
• Alterations to the drive programme may only be carried out by trained Invacare® dealers!
• Invacare® supplies all electric vehicles from the factory with a standard drive programme.
Invacare® can only assume a warranty for the safe vehicle handling of the electric vehicle –
in particular tipping stability - for this standard drive programme!
Will the wheelchair not drive after switching on?
Check the drive-away lock (see chapter "Activating / deactivating the immobilizer " on page
42) and the status bar indicator (see chapter "ON/OFF diode (status display)" on page 41.).
44