Adjusting The Depth Of The Calf Plate - Invacare Tornado Operating Instructions Manual

10.2.2.5 Adjusting the depth of the calf plate

The depth of the calf plate can be adjusted via the holding plate. The holding plate hole
combinations allow 5 different depth settings.
Pre-requisites:
• 1x 10 mm open-ended spanner
• Use the open-ended wrench to loosen the nut (1) and
remove.
• Adjust to the desired depth. Please observe that the round
holes are intended for the calf plate retaining screw and the
oblong holes for the aglet without thread.
• Screw the nut back on and tighten.
106