Filling The On-Board Water Tank; Fresh Water Tank Fill - Fleetwood PaceArrow Vision Manual

PlUMbiNCf SYSTEMS
The on-board fresh water tank can be filled in two ways:
(1) city water pressure or (2) gravity.
1. City water pressure - When connected to the city water
supply as described above, turn the bypass valve located in
the utility compartment to "Water Tank Fill" from the
"Normal" setting. This will fill the on-board fresh water tank.
Make sure the external gravity fill connection is open
(remove the cap) to allow air to escape from the on-board
tank. When water flows out of this external fill, the on-board
tank is full.
After filling, turn the bypass valve to "Normal."
2. Gravity fill -The external gravity water fill is located on the
exterior of the motor home. The on-board water tank can be
filled here. To fill the fresh water tank, remove the cap,
remove the vent plug, and fill the tank using a potable water
hose.
Check the monitor panel often to determine if the tank is
full. If water is flowing from the top vent, your tank is full.
Stop filling. Replace the vent plug and filler cap.
Fresh Water Tank Fill
FILLING THE
ON--BoARD
WATER TANK
CAUTION
Overfilling the fresh water
tank from a pressurized
source will cause serious
damage to the water tank
or structural components.
Monitor water tank filling
continually.
PACE
ARROW
VisioN