Table of Contents
Advertisement
XBDM-1015LV, XBDM-1020LV, XBDM-1030LV, XBDM-1020HV USER'S MANUAL
Figure 20 – XBDM-1020HV Output Receptacles
11. Plug the UPS INPUT power cord into the UPS INPUT RECEPTACLE on the XBDM.
Depending upon the UPS operation, once the XBDM is connected to AC INPUT, the UPS
may begin its startup procedure.
Figure 21 – XBDM UPS Input Receptacle
12. Press the ON BUTTON on the UPS. All indicators on the UPS should operate normally
and output power should be provided to LOADs connected to the XBDM OUTPUT. The
red UPS available light should illuminate on the Bypass Distribution Module.
USER'S OPERATIONS
The purpose of this BYPASS DISTRIBUTION MODULE is to allow servicing of the UPS so as not to affect
the LOADs connected and protected. To transfer between UPS and utility sources, swiftly actuate the
Xtreme Power Conversion® (XPC) Corporation (Rev 2/7/13)
BYPASS DISTRIBUTION MODULE
Page 15
Advertisement
Table of Contents
