Advertisement
WebEye A10 User's Guide V 1.5
7 -
5. Connecting WebEye A10 to WebEye SPD
1) Connect power supply to WebEye SPD
2) Cut provided dedicated cable (Refer to Figure 1)
3) Prepare 3 wires (RX, TX, and GND) to connect to SPD. (Power wire is not used with SPD)
4) Connect the 3 wires to WebEye SPD and RJ-45 jack to Webeye A10
5) Check LED on WebEye A10. LED goes on when it is powered and blinks when transmitting
data.
* Make sure not to initially connect dedicated cable before supplying power to
WebEye A10
DC Adapter
<Connection Diagram>
W e b E y e S P D
R J 4 5
R X
T X
G N D
T X
R X
G N D
W h i t e
B lack
G reen
R e d
<Pin Connection>
Advertisement
