Safety Notice - Allpro ScanX-12 DVM Instruction Manual

SAFETY NOTICE

This equipment has been designed to minimize exposure of personnel to haz-
ards. While the ScanX is designed for safe operation, certain precautions must be
observed. Use of the ScanX not in conformance with the instructions specified in
this manual may result in permanent failure of the unit.
General Safety Information.
 Check with your authorized dealer for packing material requirements if
it is necessary to return the product to the manufacturer. Correct pack-
ing guarantees optimal safety of the device during transport. Should it
become necessary to return the device to the manufacturer during the
warranty period, Air Techniques will not accept claims for damage arising
from using incorrect packing materials.
 Before every use, the operator must check the functional safety and the
condition of the device.
 The operator must be knowledgeable in the operation of the device.
 This device is not to be used in any areas where the atmosphere could
cause fire or explosion.
Markings.
The following terms or symbols are used on the equipment or in this manual
to denote information of special importance:
CAUTION
CLASS 1 LASER PRODUCT
CLASS 3B LASER
RADIATION WHEN OPEN
AVOID EXPOSURE TO BEAM
DANGER
LASER RADIATION WHEN OPEN
AVOID DIRECT
EXPOSURE TO BEAM
COVER REMOVED MAKES
THIS DEVICE A
CLASS IIIb LASER PRODUCT
Alerts users to important Operating and
Maintenance instructions. Read carefully to
avoid any problems.
Warns users that uninsulated voltage within
the unit may be of sufficient magnitude to
cause electric shock.
2
Indicates item used only
once. Discard after use.
Manufacturing date code on serial number label is in the format:
The ScanX is a Class I Laser Product [Class 1 Laser Product (IEC)]
This warning label identifies the ScanX as such a product and
describes the potential danger to humans in the event the product is
opened during service. There is no laser radiation from this product
when operated and maintained as instructed.
The Laser Product Accession Number is 0212282-00
ATTENTION USERS:
MONTH
LABORATORY
YYYY.
4
Indicates the
ScanX is a UL
Listed product.
EQUIPMENT
60CB
E234737