Table of Contents
Advertisement
52
EN
Manual Channel Set
Store channels that were not stored during Auto Set Up
(
pg. 12) or Auto Channel Set (
A
Access the Main Menu screen.
Press MENU.
B
Access the Confirmation screen.
Press
to move the highlight bar (pointer) to
rt
"MANUAL CH SET", then press OK or
Confirmation screen appears.
C
Select the channel position.
Press
until an open
rt w e
position in which you want to
store a channel begins
blinking, then press OK. The
Manual Channel Set screen
appears.
pg. 50).
. The
e
(Example) To store in position 12.
The blueback screen and the
programme currently being
broadcast by the selected channel
appear alternately for 8 seconds
each.
SUBSIDIARY SETTINGS (cont.)
D
Select the band.
Press
to change the band
rt
between CH (regular) and CC
(cable), then press
.
e
E
Input the channel.
Press the number keys to input the channel number you
want to store.
Input "0" before any single number entries.
To input the registered station name (ID –
until "– – – –" (ID setting) begins blinking, then press
For fine tuning adjustment, press
then press
. While tuning, "+" or "–" appears.
rt
F
Enter new channel information.
Press OK and the Confirmation screen appears.
Repeat steps 3 – 6 as necessary.
G
Close the Confirmation screen.
Press MENU.
To change positions, see "Change Station Channel Position"
(
pg. 53).
If you wish to set station names other than the ones registered
in your recorder, see "Set Stations (B)" (
ATTENTION
Guide Program numbers are not set when channels are
stored manually. If an attempt is made at timer programming
with the S
V
system in this state, the "GUIDE PROG
HOW
IEW
SET" screen appears; set the Guide Program numbers on this
screen. (
pg. 29, "ATTENTION — Guide Program Number
Set")
Or perform "Guide Program Number Set" (
pg. 55), press
.
rt
until "+/–" begins blinking,
e
pg. 54).
pg. 49).
e
Advertisement
Table of Contents
