Advertisement
6. Changing the LP Gas
cartridge
6.1 Close the valve on the LP Gas cartridge
by turning the knob (2) clockwise as far as it
will go. Make sure that the stove goes out and
that no other naked flame or source of ignition
is in the vicinity. Move the stove outdoors and
unscrew the valve from the LP Gas cartridge
Replace the valve's O-ring if it is worn or
damaged. Connect the valve in accordance
with items 4.3 and 4.4.
7. Maintenance (flg. 5)
7.1 If the stove does not burn or burns with
reduced power despite fuel being in the LP
Gas cartridge, the nozzle may be blocked.
7.2 Cleaning the nozzle. Close the control
knob (2) completely and unscrew the LP Gas
cartridge (3).
7.3 Squeeze the spring-loaded burner holder
(10) and remove the burner.
7.4 Loosen the clamp screw (14) on the
injector tube (12) and remove the preheating
coil (11).
7.5 Unscrew the jet (9) with an 8 mm open-
end wrench.
7.6 Clean the jet.
7.7 Mount the jet on the pipe and make it
leak-proof by tightening it carefully. Do not
tighten too hard. Check that it is leak-proof
with soapy water or similar.
7.8 Place the preheating coil in the injector
tube (12), fasten it with the clamp screw (14),
and reattach the burner holder (10).
8. Checking and maintenance
8.1 Always make sure that the sealing joints
are located in the correct places and are in
good condition. This should be checked every
time the appliance is assembled. Replace
sealing joints if they are damaged or worn.
New sealing joints can be purchased from you
nearest Primus retailer.
9. Service and repair
9.1 If it is not possible to rectify a fault by
following these instructions, the appliance
should be returned to your nearest Primus
retailer.
9.2 Never try to carry out any other
maintenance or repair work than that which is
described here.
9.3 Never make any alterations to the
appliance, as it may then be dangerous to use.
9.4 The stove has been approved with a
factory-mounted hose, and this must NOT be
replaced with any other hose than the genuine
hose 732910.
Advertisement
