Sat Control Set; Satellite Receiver Control Setting - JVC LPT0679-001A Instructions Manual

SAT CONTROL SET

Satellite Receiver
Control Setting
Your recorder
Transmitter
Satellite receiver
21-pin SCART cable
(provided)
AV2 (L-2) IN/DECODER
Satellite receiver
Satellite Controller
(suggested locations)
Satellite Controller
(provided)
SAT CONTROL
Back of recorder
The following procedure is required if you receive
satellite channels through a satellite receiver.
Approximately 20 seconds before the VIDEO Plus+ timer
programming ( pg. 36) or Express timer programming
( pg. 38) starts, the recorder sets its input mode to "L-2"
and automatically switches the satellite receiver's
channels using the provided Satellite Controller.
Installing Satellite Controller
A
Situate the Satellite Controller.
Place the Satellite Controller so that the path between its
transmitter and the satellite receiver's remote sensor is
unobstructed.
B
Attach the Satellite Controller.
Fix securely using the adhesive strip attached on the back
of the Satellite Controller.
C
Make connections.
Be sure to connect the recorder's AV2 (L-2) IN/DECODER
connector to the satellite receiver's 21-pin SCART
connector.
NOTE:
When connecting your satellite receiver, refer to its instruction
manual.
D
Connect the Satellite Controller to recorder.
Connect the Satellite Controller to the SAT CONTROL
connector on the rear panel.
17