Table of Contents
Advertisement
84
EN
RECORDING
SYMPTOM
1. Recording cannot be started.
2. TV broadcasts cannot be recorded.
3. Tape-to-tape editing is not possible.
4. Camcorder recording is not possible.
5. "
" on the front display panel won't
[
stop blinking.
6. Audio dubbing is not possible.
7. Monitoring the audio-dubbed sound is
not possible during audio dubbing
using the DV deck.
8. The programmed memory of Random
Assemble Editing is disappeared.
9. When performing Normal Dubbing,
the beginning of the dubbing start
point is not dubbed.
POSSIBLE CAUSE
For the VHS deck
There is no cassette loaded, or the
cassette loaded has had its record safety
tab removed.
For the DV deck
There is no cassette loaded, or the
cassette loaded has had its erase
protection switch set to "SAVE".
"L-1", "L-2", "F-1" or "SAT" has been
selected as the input mode.
The source (another video recorder,
camcorder) has not been properly
connected.
All necessary power switches have not
been turned on.
The input mode is not correct.
The camcorder has not been properly
connected.
The input mode is not correct.
The end of the tape was reached during
recording.
For the DV deck
"SOUND MODE" had been set to
"16BIT" at the original recording.
The tape speed had been set to LP at the
original recording.
This is normal.
The memory backup time has expired.
This is normal.
TROUBLESHOOTING (cont.)
CORRECTIVE ACTION
Insert a VHS (or S-VHS) cassette, or using
adhesive tape, cover the hole where the
tab was removed.
Insert a Mini DV cassette, or set the erase
protection switch set to "REC".
Set to the desired channel.
Confirm that the source is properly
connected.
Confirm that all units' power switches are
turned on.
Set the input mode to "L-1", "L-2" or
"F-1".
Confirm that the camcorder is properly
connected.
Set the input mode to "L-1", "L-2" or
"F-1".
The programme may not have been
recorded in its entirety. Next time make
sure you have enough time on the tape to
record the entire programme.
Set "SOUND MODE" to "12BIT" at the
original recording. (
pg. 73)
Set the tape speed to SP at the original
recording.
Set "12BIT MODE" to "SOUND 2" or
monitor the sound using the connected
devices.
Perform Random Assemble Editing again.
(
pg. 58)
Locate the start point a little before the
point where you want to start dubbing.
(
pg. 46, 47)
Advertisement
Table of Contents
