JVC LPT0678-001A Instructions Manual page 71

VHS MODE SET (cont.)
DIGITAL 3R
8
ON
OFF
S-VHS
8
ON
OFF
S-VHS ET
8
ON
OFF
When this function is set to "ON", the Digital 3R picture system applies edge
correction to the luminance signal to enhance detail.
NOTES:
Normally it is recommended to keep "DIGITAL 3R" set to "ON".
Depending on the type of tape being used, picture quality may be better with "DIGITAL
3R" set to "OFF".
If you use the recorder as the source player for editing, be sure to set "DIGITAL 3R" to
"OFF" before starting.
Your recorder can record in S-VHS (Super VHS), S-VHS ET or VHS.
To record in S-VHS:
Set "S-VHS" to "ON". Then, insert a cassette marked "S-VHS". The S-VHS indicator
lights up on the front display panel.
The S-VHS recording mode is selected.
To record in S-VHS ET on a VHS cassette:
Set "S-VHS ET" to "ON". (
The S-VHS indicator lights up on the front display panel.
To record in VHS:
Insert a cassette marked "VHS".
Set "S-VHS ET" to "OFF". (
To record in VHS on an S-VHS cassette:
Insert a cassette marked "S-VHS". The S-VHS indicator lights up on the front
display panel. Then, set "S-VHS" to "OFF". The S-VHS indicator goes off.
The VHS recording mode is selected.
NOTE:
When playing back a tape that has been recorded in S-VHS or S-VHS ET, the S-VHS indicator
lights up on the front display panel regardless of the "S-VHS" mode setting.
You can record in SP mode on VHS cassettes with S-VHS picture quality. Tapes
recorded using this function can be played back on a recorder equipped with the
S-VHS ET function.
When this function is set to "ON", the S-VHS indicator lights up on the front
display panel.
NOTES:
You can activate the S-VHS ET function only before you start recording on a VHS cassette.
Before recording, make sure that "B.E.S.T." is set to "ON". (
You cannot activate the S-VHS ET function ...
... while recording is in progress.
... while timer-recording or Instant Timer Recording (
... while B.E.S.T. ( pg. 29) is in progress.
The S-VHS ET function does not work ...
... with S-VHS cassettes.
... with recordings in LP mode.
To keep the highest quality recording and playback pictures over a long period of time,
S-VHS recording on S-VHS cassettes is recommended.
Use of high grade tapes is recommended for S-VHS ET recordings. On some tapes, picture
quality will not improve even if the S-VHS ET function is used. Check the recording quality
before you start important recordings.
You can play back a tape recorded using the S-VHS ET function on most of S-VHS recorders
and of VHS recorders equipped with SQPB (S-VHS QUASI PLAYBACK) function. (Notice
some recorders are not compatible with the S-VHS ET function.)
While playing back a tape recorded using the S-VHS ET function on some recorders, noise
may appear. (If playback picture becomes blurred or interrupted, use a cleaning cassette.)
In the high-speed search, still, slow-motion or frame-by-frame playback modes (
noise may appear. If these modes are performed frequently on a tape recorded using the
S-VHS ET function, the tape may be damaged and the picture may be deteriorated.
* The default setting is bold in the table below.
See below.) Then, insert a cassette marked "VHS".
See below.)
pg. 26, 34) is in progress.
71
EN
pg. 70)
pg. 22),