IKEA DISHWASHER User Instructions page 7

OPTION SELECTIONS
OPTIONS DISH LOAD TYPES
Control Lock To avoid unintended use of
your dishwasher, or cycle
and option changes during
a cycle.
or
IMPORTANT:
■ The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the cycle for the
best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle will
automatically compensate by adding time, heat and water as needed.
■ The very first wash cycle after installation in your home will be adjusted to include an additional 2 rinses. This cycle must not be
interrupted for proper sensor adjustment. If this adjustment cycle is canceled or stopped before the Clean light comes on at the end of
the cycle, the next wash cycle will repeat this sensor adjustment.
CONTROLS AND
CYCLE STATUS
CONTROL PURPOSE
To start or resume a
wash cycle
To cancel wash
cycle
To follow the
progress of your
dishwasher cycle
or
Drying System
.
During drying, you can see steam escaping through the vent at the upper left corner of the door. This is normal as the heat
dries your dishes.
IMPORTANT: The vapor is hot. Do not touch the vent during the drying cycle.
DESCRIPTIONS
To turn on Lock, press and hold Heat Dry for at least
4 seconds.
To turn off Lock, press and hold Heat Dry for at least
4 seconds.
When Control Lock is lit, all buttons are disabled. If you press
any pad while your dishwasher is locked, the light flashes
3 times. The dishwasher door can be opened while the
controls are locked.
COMMENTS
If the door is opened during a cycle or the power is interrupted, the Start/Resume indicator
flashes. The cycle will not resume until the door is closed and Start/Resume is pressed.
Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher
drain completely.
The Clean indicator glows when a cycle is finished.
If you select the Sanitize option, when the Sanitize cycle is finished, the Sanitized indicator glows.
If your dishwasher did not properly sanitize your dishes, the light flashes at the end of the cycle.
This can happen if the cycle is interrupted, or the water could not be heated to the required
temperature. The light goes off when you open and close the door or press CANCEL.
USE WITH:
Anytime
7