Table of Contents
Advertisement
d. If the product does not operate normally by following the
operating instructions. Adjust only those controls that are
covered by the operating instructions as an improper
adjustment of other controls may result in damage and will
often require extensive work by a qualified technician to
restore the product to its normal operation.
e. If the product has been dropped or damaged in any way.
f. When the product exhibits a distinct change in performance—
this indicates a need for service.
3. Replacement Parts
When replacement parts are required, be sure the service
technician has used replacement parts specified by the
manufacturer or which have the same characteristics as the
original part. Unauthorized substitutions may result in fire,
electric shock or other hazards.
4. Safety Check
Upon completion of any service or repairs to this product, ask the
service technician to perform safety checks to determine that the
product is in safe operating condition.
How to use the Remote
Before use, insert two AA size batteries into the Remote with the
polarity (
and
) matched correctly as indicated on the battery
compartment or on the lid.
The Remote can operate most of your VCR's functions, as well as
basic functions of TV sets, cable boxes and DBS receivers.
Point the Remote toward the remote sensor on the target
component.
The maximum operating distance of the remote control is about
8 m.
NOTE:
If the Remote does not work properly, remove its batteries, wait for
a few seconds, replace the batteries and then try again.
Video heads cleaning
Use a dry cleaning cassette — TCL-2UX — when:
Rough, poor picture appears while a tape is played back.
The picture is unclear or no picture appears.
"USE CLEANING CASSETTE" appears on the screen (only with
"SUPERIMPOSE" set to "ON").
Buttons, Connectors and
Indicators
Front Panel
REC LINK
lamp
VIDEO/AUDIO
input connectors
Display panel
Timer mode indicator
Play indicator
Record indicator
Channel and auxiliary input/Clock time
Cassette loading slot
Advanced
JOG dial
Remote
sensor
VCR mode
indicator
Rear Panel
AC power cord
Remote
Number keys
On-screen display
If you press OSD on the Remote when "SUPERIMPOSE" is set to
"ON", you can see the current VCR status on the TV screen. Press
OSD again to exit on-screen display.
The indications are not recorded even if the VCR is in the
recording mode.
Channel and
auxiliary input
Timer warning display
Day and
CH125
clock time
THU
12:00 AM
STEREO
–WARNING–
STEREO
SAP
TIMER RECORDING
program
TO START SOON
indication
+
SAP
B
indication
NORM
Audio
HI-FI
monitor
indications
VCR operation
mode
RECORD
PAUSE
Tape speed
SP
Cassette mark
(CANCEL)
Tape position
+
+
E
INDEX 1
Index number
COUNT
–1:23:45
Time counter
Advertisement
Table of Contents
