Kidde SL177i User Manual page 9

the strobe light and on the Install the strobe light on the trim ring with the indicating
marks aligned and rotate the detector in the direction of the ON arrow on the cover
until the strobe light snaps in place. (See fig. 5)
Turn on the AC power, The model SL177I strobe light has a green AC power on indi-
•
cator which should be lit when the strobe is operating from AC power.
SELECT PROPER MOUNTING HOLES ON THE TRIM RING
Rectangular
plaster ring
TAMPER RESIST LOCKING PIN;
resistant a locking pin has been provided with your strobe light. Using this pin will deter
individuals from removing the strobe light from the trim ring. To use the pin insert it into
the hole in the side of the strobe light after the strobe light has been installed on the trim
ring (see fig. 6). NOTE the tamper resist pin will have to be removed in order to remove
the strobe light. This can be done easily with a long nose pliers. Using the long nose pli-
ers, pull the pin out of the hole, it is now possible to remove the strobe light from the
trim ring.
After installation TEST your strobe light by following the test procedure outlined in sec-
tion 6.
CAUTION! Early warning fire detection and visual notification is best achieved by the
installation of fire detection and visual notification equipment in all rooms and areas of
)
the household as follows: A smoke alarm and visual notification device installed and
interconnected in each separate sleeping area, and visual notification equipment inter-
connected with heat, smoke, or CO alarms in the living rooms, dining rooms, kitchens,
hallways, attics, furnace rooms, closets, utility storage rooms, basements, and attached
garages.
Circular
plaster ring
FIGURE 3
To make your strobe light somewhat tamper
Octagonal
electrical box