Testing And Operation; Maintenance - Kidde SL177i User Manual

6. TESTING AND OPERATION

WARNING! THIS STROBE LIGHT IS EXTREMELY BRIGHT. DO NOT LOOK
DIRECTLY AT THE LIGHT OR TOUCH THE LENS WHEN THE LIGHT IS
FLASHING.
TESTING: Test by pushing the test button on one of the controlling alarms
and hold it down for a minimum of 5 seconds after the alarms sounds. This
will allow the controlling device to sound an alarm if all the electronics, circuit-
ry, and horn are working. The controlling alarm will also send an activation
signal through the interconnecting wiring to the strobe light, and cause the
TO REMOVE AC
CONNECTOR
SQUEEZE
LOCKING ARMS
AND PULL
strobe light to flash if strobe light and the interconnection wiring are working
properly
If no alarm sounds check the fuse or circuit breaker supplying power to the
alarm circuit.
If the alarm sounds but the strobe light does not activate, refer to section 5
to insure that the strobe light is wired properly.
TEST THE STROBE LIGHT AND YOUR ALARMS WEEKLY TO ENSURE
PROPER OPERATION.
OPERATION:
complete. When the strobe light is activated, it will flash for as long as the controlling
alarm remains active.

7. MAINTENANCE

STROBE LIGHT REMOVAL:
IF TAMPER RESIST PIN HAS BEEN USED, REFER TO "TAMPER RESIST LOCKING PIN"
IN SECTION (5) FOR PIN REMOVAL INSTRUCTIONS.
ALIGNMENT
MARKS
INSTALL
FIGURE 4
The strobe light is operating once AC power is applied, and testing is
REMOVE
FIGURE 5
TAMPER RESIST
LOCKING PIN
FIGURE 6