Table of Contents
Advertisement
Speaker Setup
Speaker Setup Page
Downmix
Front Speaker
Center Speaker
Rear Speaker
Subwoofer
Channel Delay
1. Downmix Mode: To set this player's DOWNMIX
mode to change multi-channel audio into two
channel audio.
Optional settings: LT/RT, Stereo, V SURR,
5.1CH.
Default: Stereo.
NOTES
The 5.1CH mode needs disc's support. The number
of actual output channels depends on the played
disc.
2. Front Speaker: To set the front speaker's
sound filtering control.
Optional settings: Large, Small.
Default: Large.
3. Center Speaker: To set the center speaker's
sound filtering control.
4. Rear Speaker: To set the surround speaker's
sound filtering control.
Optional Center/Rear Speaker settings: Large,
Small, OFF.
Default setting of Center/Rear speaker: Small.
Center and Rear are effective only when
DOWNMIX MODE is set to 5.1CH.
5. Subwoofer: To open/close the bass speaker.
Optional settings: ON/OFF.
Default: ON.
Sub
woofer
6. Channel Delay: To set delay time of the Center/
Surround/Subwoofer Speaker.
A. Press UP/DOWN navigation keys to select the
delay setting item. Press the SELECT navigation
key to enter the setting box.
Stereo
Large
Small
Small
On
0cm
FUNCTION SETUP
B. Press UP/DOWN navigation keys to select the
desired item, then press LEFT/RIGHT navigation
keys to set the distance between the speaker and
listener.
C. After finishing setting, please press SELECT to exit.
NOTE
The center/surround/subwoofer delay is effective
only for the corresponding speakers when the
delay is not set to OFF.
Audio Setup
Audio Setup Page
EQ Type
Sound Field
SPDIF Output
LPCM Out
Tone control
PRO Logic II
Dolby Digital Setup
Channel Trim
1. EQ type: To set EQ modes.
Optional settings: None, Rock, Pop, Live,
Dance, Techno, Classic, Soft.
Default: None.
2. Sound Field : To set different sound field
effects.
Optional settings: Off, Concert, Living Room,
Hall, Bathroom, Cave, Arena, Church.
Default: Off.
3. SPDIFO utput: To set the bit stream type of
the digital output.
Optional settings: SPDIF/Raw, SPDIF/PCM.
Default: SPDIF/Raw.
4.
LPCM
Out
To set the output frequency of
the LPCM audio data to fit for different
power amplifiers.
Optional settings: 48K, 96K.
Default: 48K.
5. TONE control: This item is used to set the tone
level to match your diapason when you are singing.
Method to adjust tone:
A. Press UP/DOWN cursor button to select TONE item in
AUDIO SETUP PAGE, and then press SELECT button to
enter the adjust ment menu.
B. Press LEFT/RIGHT cursor button to adjust the
setting value.
C. Press SELECT button to return to AUDIO SETUP
PAGE after adjustment are well done.
22
None
Off
Raw
48K
00
Advertisement
Table of Contents
