Replacing The System Battery - Dell OptiPlex GX1 Installation Manual

Mini tower managed pc systems
Hide thumbs Also See for OptiPlex GX1:
Table of Contents

Advertisement

NOTE: You must use up to 25 pounds of force to fully engage the SEC cartridge in the connector.
7. Install the airflow shroud over the SEC cartridge/heat sink assembly.
Fit the mouth of the shroud in the alignment slots on the sides of the cooling fan. Then squeeze the tabs on the top of the shroud and lower it
down until the clips under the tabs engage onto the top of the heat sink.
8. Rotate the power supply back into position.
9.
Replace the computer
cover, and reconnect your computer and peripherals to their electrical outlets and turn them on.
NOTE: If Enabled, the
ALERT! Cover was previously removed.
10. Enter the
System Setup program
As the system boots, it detects the new microprocessor and automatically changes the system configuration information in the System Setup
program.
11. Run the Dell Diagnostics to verify that the new microprocessor is operating correctly.
See your Diagnostics and Troubleshooting Guide for information on running the Dell Diagnostics and troubleshooting any problems that
may occur.

Replacing the System Battery

A 3.0-volt (V) CR2032 coin-cell battery installed on the system board maintains system configuration, date, and time information in a special
section of memory.
The operating life of the battery can extend up to ten years. The battery may need replacing if an incorrect time or date is displayed during the boot
routine along with a message such as:
Time-of-day not set - please run SETUP program
or
Invalid configuration information - please run SETUP program
or
Strike the F1 key to continue, F2 to run the setup utility
To determine whether the battery needs replacing, reenter the time and date through the System Setup program (not through the MS-DOS time
and date commands) and exit the program properly to save the information (see
system and disconnect it from AC power for a few hours; then reconnect and turn on your system. Enter the System Setup program. If the date and
time are not correct in the System Setup program, replace your battery.
You can operate your system without a battery; however, without a battery, the system configuration information is erased if the system is turned off
or unplugged from AC power. In this case, you must enter the System Setup program and reset the configuration options.
CAUTION: There is a danger of the new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions.
CAUTION: Before you remove the computer cover, see
Use the following procedure to replace the system battery with another CR2032 coin-cell battery:
1. If you have not already done so, make a copy of your system configuration information in the System Setup program.
If the settings are lost while you are replacing the battery, refer to your written or printed copy of the system configuration information to
restore the correct settings. See
2. Remove the computer cover according to the instructions in
3. To access the battery on the system board, remove the expansion-card cage as described in
Cage."
NOTICE: If you pry the battery out of its socket with a blunt object, be careful not to touch the system board with the object.
Make certain that the object is inserted between the battery and the socket before attempting to pry out the battery. Otherwise,
you may damage the system board by prying off the socket or by breaking circuit traces on the system board.
Chassis Intrusion
option will cause the following message to be displayed at the next system start-up:
and confirm that the installed microprocessor is correctly identified.
"Using the System Setup
Program" for instructions.
"Using the System Setup
"Safety First — For You and Your
"Removing the Computer
Program" for instructions). Turn off your
Computer."
Cover."
"Removing the Expansion-Card

Advertisement

Table of Contents
loading

This manual is also suitable for:

Optiplex gx1p

Table of Contents