Power Seat (Optional) - Golden Companion II Owner's Manual

Companion Owner's Manual: GC240, GC340, GC440
POWER SEAT ADJUSTMENT
Your scooter may be equipped with a power seat. The power seat actuator is designed to raise
or lower the seat with minimal effort by the user. The power seat switch is located on the tiller
below the throttle lever. See figure 1.
sure your scooter is level and stationary and the speed adjustment dial is set to its
slowest (turtle) setting. Make sure you are familiar with all the scooter operating
procedures in your owner's manual.
To operate the power seat:
1. Lift up and hold the power seat switch to raise the seat. Release the switch when you have
reached your desired height or upon reaching the highest position.
2. Push down and hold the power seat switch to lower the seat. Release the switch when you
have reached your desired height or upon reaching the lowest position.
How the Power Seat Functions:
By elevating the power seat to approximately one-half its maximum height your scooter's speed
will be limited to half the speed dial setting. If the power seat is elevated to approximately three-
quarters its maximum height, the scooter will not move if the throttle control lever is pressed.
The power seat must be lowered to slightly under, three-quarters of its maximum height in
order to drive the scooter again. The scooter can not be driven at full speed until the scooter's
seat is lowered to under one-half its maximum height.
Problem Solving:
If you encounter an instance where after using the power seat feature that the scooter will not
run, try lowering your seat. Depending on how high the power seat is raised, your scooter's
speed will be reduced or the scooter may stop operating and give a fault code. For details, refer
to the above section "How the Power Seat Functions."
Companion
V. OPERATION
Figure 1. Power Seat Switch
Before attempting to operate the power seat for the first time, make
18