Troubleshooting - ZyXEL Communications ZyAir B-1000 Quick Installation Manual

ZyAIR B-1000 Wireless LAN Access Point
PROBLEM
The PWR Make sure you are using the correct power adapter and the
LED is off. power adapter is plugged into an adequate power supply.
Turn the ZyAIR off and on. If the error persists, you may have
a hardware problem. In this case, you should contact your
vendor.
The ETHN Check the cable connection to the ZyAIR ETHERNET port.
LED won't
turn on.
Make sure your computer NIC (Network Interface Card) is
working properly.
I cannot Check that your computer IP address and the ZyAIR IP
access the address are on the same subnet.
web
configurator.
If you changed the ZyAIR default LAN IP address then enter
the new one as the URL.
The default password is "1234". If you have changed the
password and have now forgotten it, you will need to reset
the ZyAIR. See the section on Using the RESET Button.
If all of the ETHN LED is off, check the cables between the
I cannot
ZyAIR and your computer or hub.
ping any
computer on
Verify that the IP address and the subnet mask of the ZyAIR
the LAN.
and the computers are on the same subnet.
Check the TCP/IP configuration on your computer. Make sure
that the IP address and the subnet mask of the ZyAIR and
the computers are on the same subnet.
I cannot Make sure the ZyAIR is turned on and connected to the
access the network.
Internet.
Make sure you entered your user name correctly. A
username may be case-sensitive.
16

Troubleshooting

CORRECTIVE ACTION