Lifting The Vehicle - Porsche Boxster Owner's Manual

5. Screw filler hose B onto the filler bottle. The
filler bottle is now open.
6. Unscrew valve cap from tire valve F.
7. Remove valve insert E from the tire valve with
valve turner D. Keep the valve insert in a clean
and dry place.
8. Remove plug C of the filler hose B.
9. Push filler hose onto the tire valve.
10. Hold filler bottle higher than the level of the tire
valve and press it together forcefully until the
bottle is completely emptied into the tire.
11. Pull filler hose off the tire valve.
12. Twist the valve insert firmly into the tire valve
using the valve turner.
13. Connect the compressor to the cigarette
lighter and inflate the tire to the prescribed tire
pressure.
Please observe the chapter "TIRE PRESSURE
FOR COLD TIRES" on page 304.
14. Screw valve cap onto the tire valve.
15. Check the tire pressure after driving for
around 10 minutes. If the tire pressure is
less than 22 psi (1.5 bar), do not continue
driving. If a value of more than 22 psi (1.5 bar)
is indicated, correct the pressure to the
prescribed value.
16. Please consult your authorized Porsche
dealer.
258
Practical Tips, Emergency Service
Care Instructions
After drying, any sealant that emerges can be
peeled off like a film.
Warning!
Risk of accident resulting in serious personal
injury or death.
Have the tire replaced by an authorized
Porsche dealer immediately.
Avoid hard acceleration and high cornering
speeds.
Do not exceed maximum speed of 50 mph
(80 km/h).
Please always observe the safety and oper-
ating instructions, which can be found in the
separate operating instructions for the sealant
and on the compressor.
Front jacking point

Lifting the Vehicle

Lifting the vehicle with a lifting platform or
garage lift
The car must be raised only at the illustrated
jacking points.