WireTech 5000P-10x User Manual page 28

DVB mode:
Uni/Multicast Setup  set the address and port parameters for the IP stream. Press Enter to
go to the submenu. As below:
Multicast IP  enter the multicast IP address for the output stream (for the
addresses inside 224.0.0.1 to 239.255.255.255 are belonging to multicast, for
others else are belonging to unicast).
Multicast UDP Port  enter the port number of the output stream.
Target Mac Addr set the MAC Address of the receiving device. The parameter will
be used only when the receiving device is located under the same gateway. The
parameter will be ignored by 5000P if the receiving device is located under other
remote network or under different gateway.
IPTV mode:
Uni/Multicast Setup  Press Enter to go to the submenu. As below:
Max Channels  set the quantity of multicast/unicast channels.
Channel 0  set the private parameters for Multicast / Unitcast channel 0. Press
Enter to go to the submenu.
0-Uni/Multicast IP  enter the multicast IP address for the output stream (for
the addresses inside 224.0.0.1 to 239.255.255.255 are belonging to multicast,
for others else are belonging to unicast).
0-Uni/Multicast Port  enter the port number of the output stream.
0-Target MAC address  set the MAC Address of the receiving device. The
parameter will be used only when the receiving device is located under the
same gateway. The parameter will be ignored by 5000P if the receiving device
is located under other remote network or under different gateway.
0-Switch  turn on/off channel 0.
0-Program  select the programs that want to be outputted via channel 0.
For other channels, please refer to IPTV mode settings.