WireTech 5000P-10x User Manual page 18

Multicast IP: Enter the IP address of the IP stream for the transport stream over IP
output. You can configure the IP stream output mode in Multicast or Unicast.
Multicast could be established by setting Multicast IP address in the range of
224.0.0.0 to 239.255.255.255.
Unicast could be established with the same settings of Multicast, the only
differences are the Multicast IP address, and should NOT be in the range of
224.0.0.0 to 239.255.255.255, which is for Multicast. Although the display is
'Multicast IP' on the first row, the stream itself is Unicast. The IP address of
receiver device (maybe PC with VLC) needed to be set to as the unicast
address on DCH-5000P, please don't use DHCP to get a dynamic IP address
for receiver device.
Multicast UDP Port: Enter the UDP port number of the TS over IP stream output.
IPTV mode
Max Channels (<=6): you can configure the number of IPTV channel. The valid range
goes from 0 to 6.
After the configuration, you can use <
channels. Each channel could be configured independently.
Channel x: „x‟ means the channel number. Press <ENTER>-key to go down to the
sub-menu. There are 4 sub-menus:
x-Multicast IP: Enter the IP address of the IP stream for the transport stream
over IP output.
You can also configure the IP stream output mode in Multicast or Unicast by
setting Multicast IP address.
x-Multicast Port: Enter the UDP port number of the TS over IP stream output.
x-Switch: each channel could be switched On/Off independently. The default
value is „off‟. To activate the channel, you should turn on.
x-Program: it shows all programs carried by the transport stream from the
source selected. Press <ENTER>-key and use <
down between the program names, where a number in front of the program
name indicates the input source:
0-xxxxx displays the program name, which comes from ASI input.
1-xxxxx displays the program name, which comes from TUNER input.
2-xxxxx displays the program name, which comes from TS/IP input
3-xxxxx displays the program name which comes from the CI.
4-xxxxx displays the program name, which comes from ASI2 input.
5-xxxxx displays the program name, which comes from BISS De-encrypted
> < >-keys to roll up and down between the
> < >-keys to roll up and