Factory Setting; Optional Function; Lcd Switch; Machine Type - WireTech 5000P-10x User Manual

configure this address.
Linux OS version: show Linux OS version
ARM SW version: show ARM software version
Decoder version: show Decoder version
FPGA version: show FPGA version
TS/IP IN (or OUT) NIOS: it‟s changed when TS/IP board is set to "IP Out" or "IP IN".
TS/IP IN (or OUT) FPGA: it‟s changed when TS/IP board is set to "IP Out" or "IP IN".

5.3.5 Factory Setting

All the user configurable parameters will be set to the factory default settings, including
IP address and the unit name.

5.3.6 Optional Function

There are two submenus:
External Board Type: Press <ENTER>-key to active the menu, use <
configure the TS/IP functional block as „IP In‟ or „IP Out‟ or „No Exist‟, and the option is
exclusive. Press <ENTER>-key to confirm or to scrap by pressing <EXIT>-key.
After the operation, you need reboot the unit to valid the configuration.
IP In: the TS/IP port is configured as input, you can feed transport stream over
IP into the unit. The menu „Ethernet‟ will be showed under the inputs menu.
IP Out: the TS/IP port is configured as output, you can set the transport stream
over IP output to the IP network. The menu „Ethernet‟ will be showed under the
outputs menu.
No Exist: the TS/IP port is invalid. Therefore the menu „Ethernet‟ will not be
showed anywhere.
Mux Function: Press <ENTER>-key to active the menu, use <
configure the Mux functional block as „Enable‟ or or „Disable‟. Press <ENTER>-key to
confirm or to scrap by pressing <EXIT>-key.

5.3.7 LCD Switch

There are two options: Always On and Time

5.3.8 Machine Type

This setting is reserved for factory-setting, and you are not allowed to access this menu.

5.3.9 HTTP Login

Modify the username and password for the WEB management.
The default username: root
The default password: 12345
> < >-keys to
> < >-keys to