1. Manuals
  2. Brands
  3. Hunter Manuals
  4. Stove
  5. Herald Inset 5
  6. Installation and operating instructions manual

Hunter Herald Inset 5 Installation And Operating Instructions Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

H E R A L D
H E R A L D
H E R A L D
H E R A L D
I N S E
I N S E T 5
I N S E
I N S E
M U L T I F U E L
M U L T I F U E L
M U L T I F U E L
M U L T I F U E L
Installation and Operating Instructions
An accredited competent person must carry out the installation of this
appliance; alternatively, your local Building Control Officer can approve the
completed installation, should a non-accredited engineer undertake the
installation. It is an offence, under UK law, not to comply with this advice.
Please hand these instructions to the stove user when the installation is
complete. Leave the system ready for operation and instruct the user in the
correct use of the appliance and operation of controls.
T 5
T 5
T 5
S T O V E
S T O V E
S T O V E
S T O V E
v06.09

Advertisement

Table of Contents
loading

Related Manuals for Hunter Herald Inset 5

Summary of Contents for Hunter Herald Inset 5

  • Page 1 H E R A L D H E R A L D H E R A L D H E R A L D I N S E I N S E T 5 I N S E I N S E M U L T I F U E L M U L T I F U E L M U L T I F U E L...

  • Page 2: Important Warning

    PLEASE READ THESE INSTRUCTIONS CAREFULLY Please check the suitability of any fireplace/surround for closed solid fuel appliances before installing this appliance. Hunter Stoves Ltd cannot be held responsible for any fault arising through incorrect use or installation. Fire surround back panels suitable for solid fuel are usually in three sections and slabbed.

  • Page 3: Fire Bricks

    Assembly Instructions Fire Bricks The Fire Bricks, in this appliance, are factory fitted. The following set of diagrams show the removal sequence that you will need to employ when servicing your Hunter stove. Side Bricks Remove all central single- width Grate Bars, and outer Triple-width grate bars below the brick.

  • Page 4: Installation Instructions

    Installation Instructions These instructions cover the basic principles to ensure satisfactory installation of the stove, although detail may need slight modification to suit particular local site conditions. In all cases the installation must comply with current Building Regulations, Local Authority Byelaws, European and national standards and other specifications or regulations as they affect the installation of the stove.

  • Page 5: Flue Draught

    • Fixing Kit (inc. 3 Hilti Bolts) • Instructions Unpack the Herald inset 5 multi-fuel stove carefully (leave the plastic cover on if any building work is currently being carried out) and ensure that the black finish is protected from any damage, water, dust or fire cement.

  • Page 6: Air Supply

    It is essential that all connections between the stove and chimney-flue are sealed and made airtight. Both the chimney and any flue pipe must be accessible for cleaning and if ANY parts of the chimney cannot be reached through the stove (with baffle removed), a soot door must be fitted in a suitable position to enable this to be done.

  • Page 7: Installing The Stove

    Installing the stove Take the stove off the pallet. There are three fixing points (see fig. 1) on the stove’s body, which can only be seen before the stove is inset into the fireplace. To access these fixing points from inside the stove (see fig.

  • Page 8: Commissioning And Handover

    Press a sufficient amount of fire cement around the base under the stove and the bottom of the fireplace opening, ensuring that all joints and connections are well sealed. Then seal up where the throat area meets the flue outlet of the stove. This will prevent fumes coming out of the stove and going back down behind it.

  • Page 9: Aerosol Sprays

    Operating Instructions This appliance is not suitable for use in a shared flue This appliance should not be operated with the doors open Aerosol Sprays Do not use an aerosol spray on or near the stove when it is alight. Air Controls This stove has been designed to burn cleaner and more efficiently than a conventional wood burning stove.

  • Page 10: Multifuel Grate

    Multifuel Grate Your Hunter Stove is fitted with a locomotive type grate. So that de- ashing can be carried out cleanly and easily, it is riddled from the outside of the stove with the doors closed. The grate is designed to burn both wood and solid fuels.
  • Page 11 Loading the Stove (Solid Mineral Fuel) Solid mineral fuel should be placed in the stove so that there is no more than a 30° incline of the fuel bed from front to back. It should not be stacked above the level of the rear firebrick as this may result in damage to the stove.

  • Page 12: Extinguishing The Fire

    Air Controls (Wood) Wood burns most efficiently with the primary control in the closed position and the secondary control approximately 50% open. Moving the secondary control will control the burn rate of the stove. The secondary air lever should not be completely closed unless the primary air lever is also in the closed position.

  • Page 13: In The Event Of A Chimney Fire

    Important! – Do not fit an extractor fan in the same room as this appliance. IN THE EVENT OF A CHIMNEY FIRE • Raise the alarm to let others in the house know. • Call the Fire Brigade. • Reduce the appliance-burning rate by closing all air controls. •...

  • Page 14: General Maintenance

    Rope Check the rope around the door and glass. If rope is becoming detached, use Hunter Stoves rope glue to reattach it. If the rope is in a poor condition, a replacement rope kit may be ordered from...

  • Page 15: Chimney And Flue Ways

    Chimney and Flue ways It is important that the chimney, flue ways and any connecting flue pipe are swept regularly. This means at least once a year for smokeless fuels and at least twice a year for wood and other fuels.

  • Page 16: Stove Spares

    STOVE SPARES Only Hunter Stoves authorised spares should be used with this stove. RIGHT HAND DOOR Right Hand Door (HHR06/081) Door Glass (HH06/083) Glass Gasket (HH06/084) Glass Clip (HHR08/046) Glass Clip Screw (FSJM05008SS) Door Knob (HCR06/059) M8 Full Nut (FNFM08)
  • Page 17 STOVE BODY ASSEMBLY - PART SECTION - MULTIFUEL Recouping Baffle (HHN05/024) Side Brick (HHN05/019) Rear Brick – M/F (HHN05/018) Triple Grate Bar (Side Plate) Left (HHN05/016A) Triple Grate Bar (Side Plate) Right (HHN05/016B) Riddling Support (HHN05/015) Catch Bar – Drop in Riddling Bar –...

Table of Contents