Atwood AC-1361 Installation Operation & Maintenance page 14

OPERATING INSTRUCTIONS FOR ADJUSTING THE THERMOSTAT (cont.)
2. Temperature setting (continued)
 To display the room temperature, press
depressed, the room temperature is displayed until the key is released. Given the lack of display
characters - if the control is displaying temperature in Fahrenheit, temperatures of 100-109°F will be
displayed as A0 –A9, temperatures between 110-119°F will be displayed as B0-B9, temperatures
between 120-129°F will be displayed as C0-C9, temperatures between 130-139°F will be displayed
as D0-D9, temperatures between 140-149°F will be displayed as E0-E9, and temperatures between
150-159°F will be displayed as F0-F9. Temperatures are displayed normally in degrees Centigrade.
 Press
and
temperature set range is 16C-30C or 60F-85F.
 Temperature setting is bypassed in Fan mode.
3. Mode setting
MODE
 Press
Cool→Dry→Heat→Fan→Auto Cool/Heat
Heat and Auto mode is not available for cooling only model. Auto mode is not available for model
where furnace is primary heating.
 Heat LED flashes during outdoor defrost cycle.
4. Overriding
 This function is available in heat pump + furnace model only.
FURNACE
 Press
thereafter. Press the same button again to disable overriding function.
5. Fan speed setting
FAN
 Press
bypass in Fan mode. Fan speed setting is bypass in dry mode.
 When furnace is working as primary heat source in heat mode, pressing
turn the fan off, display will show "FF" until button is released. Pressing
to let the fan continue running, display will show "F0" until button is released.
6. Sleep setting
SLEEP
 Press
button to activate or deactivate sleep setting. Sleep is bypass in Fan and Dry mode.
AC IOM DUCTED 7/31/2013 rev 3
FAN
together for 5 seconds will change the temperature setting from C to F. Valid
button to change the operation mode as follow:-
button to activate furnace as primary heating. Heat pump operation will be inhibited
button to change the fan speed：Auto→High→Medium→Low. Auto fan setting is
SLEEP
button for 5sec or longer.
MODE
button press is invalid during this cycle.
14
While this button is
FAN
button for 5sec to
FAN
button again for 5sec