Display Setting; Remote Control Unit; Mode Button; Timer Button - Atwood AC-1361 Installation Operation & Maintenance

DISPLAY SETTING

- To change readout from Celsius to Fahrenheit or vice versa: Press Temp Down pushbutton
simultaneously with the Fan pushbutton.

REMOTE CONTROL UNIT

Many models have a remote control unit which can adjust the thermostat remotely.
- The remote control has duplicated the thermostat input pushbuttons including: the ON/OFF
pushbutton, TEMP UP/DOWN, FAN, MODE, SLEEP, and TIMER pushbuttons
- LEDs in the thermostat control respond to a pushbutton actuation from the remote control unit in
the same manner as it would respond to the pushbutton actuation on the thermostat control.
- The remote control requires a CR2025 battery commonly available.
OPERATING INSTRUCTIONS FOR ADJUSTING THE THERMOSTAT
Temperature display
area
Display timer setting, set or ro om
temperature in C or F
Room temperature
setting button

Timer button

Press to activate on/off
timer programming mode
Fan speed button
Press to select auto, high,
medium or low fan speed
1. Power On/Off
ON/OFF

Press
2. Temperature setting
 The temperature setting is always normally displayed. Press
the set temperature.
AC IOM DUCTED 7/31/2013 rev 3
TEMP
TIMER
to start or stop the air conditioner.
SENSOR
ON/OFF
AUTO COOL
HIGH DRY
FAN MODE
MED HEAT
LOW FAN
FURNACE SLEEP
Furnace button
This button is valid in heatpump +
furnace model only
Press once to select furnace as
primary heating
Press again to cancel furnace as
primary heating
13
Infra red reception
To receive wireless handset sign al
On/Off button
Press once to start operation
Press again to stop operation

Mode button

Press to select cool, dry, heat ,
fan , or auto operation mode

Sleep button

Press once to select sleep mode
Press again to cancel sleep mode

Key lock

or to decrease or increase