EPOX EP-3VHA User Manual
  1. Manuals
  2. Brands
  3. EPOX Manuals
  4. Motherboard
  5. EP-3VHA
  6. User manual

EPOX EP-3VHA User Manual

A socket 370 processor based mainboard (100/133mhz) supports pc1600/2100 memory modules
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
User'
User' s s s s s
User'
User'
User'
Manual
Manual
Manual
Manual
Manual
A Soc
A Sock k k k k et 370 Pr
A Soc
et 370 Pr
et 370 Pr
A Soc
A Soc
et 370 Processor based
et 370 Pr
mainboard (100/133MHz)
mainboard (100/133MHz)
mainboard (100/133MHz)
mainboard (100/133MHz)
mainboard (100/133MHz)
Suppor
Suppor
ts PC1600/2100 Memor
ts PC1600/2100 Memor
Suppor
Suppor
Suppor ts PC1600/2100 Memor
ts PC1600/2100 Memor y Modules
ts PC1600/2100 Memor
TRADEMARK
These specifications are subject to change without notice.
ocessor based
ocessor based
ocessor based
ocessor based
Manual Revision 1.2
July 10, 2001
y Modules
y Modules
y Modules
y Modules

Advertisement

Table of Contents
loading

Related Manuals for EPOX EP-3VHA

Summary of Contents for EPOX EP-3VHA

  • Page 1 User’ User’ s s s s s User’ User’ User’ Manual Manual Manual Manual Manual A Soc A Soc A Sock k k k k et 370 Pr et 370 Pr et 370 Pr ocessor based ocessor based A Soc A Soc et 370 Pr et 370 Processor based...
  • Page 3 Table of Contents Page Section 1 Introduction Overview Section 2 Features Section 3 Installatio Easy Installation Procedure Section 4 Award BIOS Setup...
  • Page 4 Section 5 Driver Installation Appendix Appendix A Appendix B...

  • Page 5: Components Checklist

    Introduction Section 1 INTRODUCTION Components Checklist USER’S MANUAL Page 1-1...
  • Page 6 Introduction Mainboard Form-Factor Power Supply 3 1/2" 5 1/4" Figure 2: Summary of ATX chassis features Page 1-2...

  • Page 7: Power-On/Off (Remote)

    Introduction I/O Shield Connector Joystick/Midi port parallel port PS/2 Mouse USB port PS/2 KEYBOARD COM1 COM2 Speaker Line_in Figure 3: I/O back panel layout Power-On/Off (Remote) Remote On/Off ® ® POWER SUPPLY Case (chassis) Power ON/OFF button (J 3) Figure 4: Simple ATX Power ON/OFF Controller Page 1-3...

  • Page 8: System Block Diagram

    Introduction System Block Diagram Socket 370 Processors 133/100MHz MA [0:13] 266/200MHz 66MHz PCI Bridge MD [0:63] and memory MDS [0:7] controller VT8633 V_Link VT8233 1,- I/O Bridge 1,- (ATA-66/100) USB 0,1 USB 2,3 USB 4,5 Mouse Keyboard Serial Port 1 Serial Port 2 LPT Port W83697...

  • Page 9: Mainboard Features

    .A=JKHAI Section 2 FEATURES Mainboard Features: PROCESSOR ® CHIPSET DRAM MODULE EXPANSION SLOT ONBOARD I/O ONBOARD PCI / IDE Page 2-1...
  • Page 10 .A=JKHAI I/O CONNECTOR BIOS Built-in AC97 Digital Audio EXTENDED FUNCTION FORM FACTOR Page 2-2...
  • Page 11 Installation Section 3 INSTALLATION Mainboard Detailed Layout Page 3-1...

  • Page 12: Table Of Contents

    Installation Easy Installation Procedure 3-1. CPU Insertion 3-2. EEPROM BIOS Remover 3-3. Jumper Settings 3-4. System memory Configuration 3-5. Device Connectors 3-6. STR Function Section 3-1 CPU Insertion Step 1 Step 2 Page 3-2...
  • Page 13 Installation Step 3 Note: Intel’s reference design thermal solution is an active heatsink; an extruded aluminum heatsink based and a fan attached to the top on the fin array. (See Figure 5) Page 3-3...

  • Page 14: Eeprom Bios Remover

    Installation Section 3-2 EEPROM BIOS Remover Page 3-4...

  • Page 15: Jumper Settings

    Installation Section 3-3 Jumper Settings JBAT1 JCK1 JCK2 (Default) LED2 LED1 Page 3-5...

  • Page 16: System Memory Configuration

    Installation Section 3-4 System Memory Configuration Memory Layout Bank 0/1 DDR DIMM 1 Synchronous DDR DIMM 2 Bank 2/3 DRAM DDR DIMM 3 Bank 4/5 Page 3-6...
  • Page 17 Installation DIMM Module Installation Page 3-7...

  • Page 18: Device Connectors

    Installation Section 3-5 Device Connectors J2,J3 FAN1: FAN2: FAN3: WOL1: WOM1: IDE1: IDE2: FDD1: PW1: Page 3-8...
  • Page 19 Installation AUX1 MODEM1 USB2/3: -Data +Data +Data -Data Page 3-9...
  • Page 20 Installation Device Connectors (continued) Power On/Off Turbo LED indicator - IDE LED indicator - IR Connector Power LED - Speaker - Reset - Page 3-10...
  • Page 21 Installation 3-6 STR (Suspend To RAM) Function ® ® Page 3-11...
  • Page 22 Installation ACPI Onboard’s LED Status Indicator Table  Status Onboard’s Shutdown Plug in the ATX Power ON Green Mode (Soft-OFF) Location Power Core J3(PW-ON) (S1) (S3) (S5) LED3 (Red LED) Blinking Blinking PW_LED Page 3-12...
  • Page 23 Installation Page Left Blank Page 3-13...

  • Page 24: Award Bios Setup

    BIOS Section 4 AWARD BIOS SETUP Main Menu Figure 1: CMOS Setup Utility Page 4-1...

  • Page 25: Standard Cmos Setup

    BIOS 4-1 Standard CMOS Setup Figure 2: Standard CMOS Setup Page 4-2...

  • Page 26: Advanced Bios Features

    BIOS NOTE: If the hard disk Primary Master/Slave and Secondary Master/ Slave are set to Auto, then the hard disk size and model will be auto-detected. NOTE: The “Halt On:” field is used to determine when to halt the system by the BIOS if an error occurs.
  • Page 27 BIOS Note: Many disk diagnostic programs that access the boot sector table can trigger the virus warning message. If you plan to run such a program, we recommend that you first disable the virus warning Page 4-4...
  • Page 28 BIOS Note: BIOS can not tell the difference between 720K, 1.2MB and 1.44MB drive types as they are all 80 tracks. Page 4-5...
  • Page 29 BIOS Page 4-6...

  • Page 30: Advanced Chipset Features

    BIOS 4-3 Advanced Chipset Features Figure 4: Chipset Features Setup DRAM Clock/Drive Control Page 4-7...
  • Page 31 BIOS AGP & P2P Bridge Control Page 4-8...
  • Page 32 BIOS CPU & PCI Bus Control Note: If this feature is enabled you will not be able to cache this memory segment. Page 4-9...

  • Page 33: Integrated Peripherals

    BIOS 4-4 Integrated Peripherals Figure 5: Integrated Peripherals Note: If you do not use the Onboard IDE connector, then you will need to set Onboard Primary PCI IDE: Disabled and Onboard Secondary PCI IDE: Disabled Note: The Onboard PCI IDE cable should be equal to or less than 18 inches (45 cm.).
  • Page 34 BIOS VIA OnChip PCI Device This item allows you to decide to enable/disable the chipset family to support AC97 Modem. VIA Super IO Device Page 4-11...
  • Page 35 BIOS Page 4-12...
  • Page 36 BIOS Page 4-13...

  • Page 37: Power Management Setup

    BIOS 4-5 Power Management Setup Figure 6: Power Management Setup Page 4-14...
  • Page 38 BIOS Page 4-15...
  • Page 39 BIOS IRQ/Event Activity Dectect LPT/COM Enabled Enable rtc alarm resume, IRQs Activity Monitoring Page 4-16...

  • Page 40: Pnp/Pci Configuration

    BIOS 4-6 PNP/PCI Configuration WARNING: Conflicting IRQ’s may cause the system to not find certain devices. Figure 7: PCI Configuration Setup Page 4-17...
  • Page 41 BIOS Page 4-18...

  • Page 42: Pc Health Status

    BIOS 4-7 PC Health Status C/87 C/32 6135 RPM 0 RPM 1.62V 1.52V 4.97V 12.16V 3.35V 2.57V 3.02V 4.89V Page 4-19...
  • Page 43 BIOS 4-8 Frequency/Voltage Control 1.75V 1.75V 2.50V Page 4-20...

  • Page 44: Defaults Menu

    BIOS Insert 4-9 Defaults Menu Page 4-21...
  • Page 45 BIOS 4-10 Supervisor/User Password Setting ENTER PASSWORD: PASSWORD DISABLED. Page 4-22...

  • Page 46: Exit Selecting

    BIOS 4-11 Exit Selecting Save & Exit Setup Save to CMOS and EXIT (Y/N)? ; Exit Without Saving Quit without saving (Y/N)? ; Page 4-23...
  • Page 47 BIOS Page Left Blank Page 4-24...

  • Page 48: Drivers Installation

    Drivers Installation Section 5 Driver Installation Easy Driver Installation Insert the bundled autorun driver CD-disk. Step 1 : To Click the Service Pack 4in1 Driver. Install all components recommended. Step 2 : To Click the 8233 AUDIO Driver to install the Audio Sound Driver in operating system.
  • Page 49 Drivers Installation To install VIA Service Pack 4in1 (5)Click here (1)Click here (6)Click here (2)Click here (3)Click here (7)Click here (8)Click here (4)Click here Page 5-2...
  • Page 50 Drivers Installation To install 8233 Audio Driver To install USB Driver (1)Click here (1)Click here (2)Click here (2)Click here (3)Click here (3)Click here Page 5-3...
  • Page 51 Drivers Installation To install 686B BusMaster Ultra Driver for Win2000 only. (1)Click here (2)Click here (3)Click here Page 5-4...
  • Page 52 Appendix Appendix A A-1 GHOST 5.1/6.03 Quick User’s Guide Description of Menus Disk...
  • Page 53 Appendix There are 3 hard disk functions: Important! Disk To Disk (Disk Cloning)
  • Page 54 Appendix Disk To Image (Disk Backup)
  • Page 55 Appendix Disk From Image(Restore Backup)
  • Page 56 Appendix Partition...
  • Page 57 Appendix Partition To Partition (Partition Cloning) Partition To Image (Partition Backup)
  • Page 58 Appendix...
  • Page 59 Appendix Partition From Image (Restore Partition)
  • Page 60 Appendix Check...
  • Page 61 Appendix How to Reinstall Windows in 2 Minutes Emergency Recover Floppy A-10...
  • Page 62 Appendix B a c k u p B a c k u p B a c k u p B a c k u p B a c k u p Restore Restore Restore Restore Restore A-11...
  • Page 63 Appendix Recover CD A-12...
  • Page 64 Appendix Ghost Command Line Switches Reference A-13...
  • Page 65 Appendix Available y Options: A-14...
  • Page 67 Appendix A-16...
  • Page 68 Appendix Appendix B B-1 POST CODES POST (hex) DESCRIPTION...
  • Page 69 Appendix...
  • Page 70 Appendix...
  • Page 71 Appendix...
  • Page 72 Appendix...
  • Page 73 Appendix...

Table of Contents