Installing The Symmetricom 5087B; To Set Up The Symmetricom 5087B - Symmetricom 5087B Operation And Maintenance Manual

2
Installing and Setting Up the Symmetricom 5087B

Installing the Symmetricom 5087B

To set up the Symmetricom 5087B

14
The Symmetricom 5087B ships ready for installation into a standard 19"
(48.3 cm) rack.
Accessories included:
• CD-ROM documentation P/N 05087-13402)
• Power cord
• Rear brackets with attaching hardware (Replacement kit P/N
05087-67002)
Required for installation:
• North American or European IEC power cord. One or the other will
be supplied with the unit.
• #1 Phillips screwdriver.
• Customer-supplied, RG223 cables with BNC connectors from source
and to next devices in system.
• Customer-supplied, LAN cable for network connection (RJ-45).
• Rack mounting screws.
• Screwdriver for the rack mount screws, as needed.
Since the unit does not have a AC mains power switch, both the
appliance inlet connector and the plug on the detachable power supply
cord are considered to be suitable disconnect means for disconnecting
the unit from the AC mains supply. If the rear of the unit is not
accessible after installation in the instrument rack, you must provide a
suitable external AC disconnect means for the unit.
Unpack carefully and inspect the Symmetricom 5087B.
1
Check for physical damage.
2
If you observe physical damage, immediately contact Symmetricom,
Inc. and the carrier.
We recommend saving the shipping container for submitting any
necessary claims to the carrier.
Symmetricom 5087B Operations and Maintenance Manual Rev. E