Table of Contents
Advertisement
Horizon
Operating Instructions
Lighting Instructions
See page 8.
Burner Adjustment
The 24VF is equipped with an adjustable burner, allowing you to raise
or lower the flames.
1.
Light the pilot as per the lighting instructions.
2.
To raise the flame height, turn the black knob (located behind the
lower grill) counterclockwise, from '1' to '5'.
3.
To lower the flame height, turn clockwise, from '5' to '1'.
Figure 10. 'Hi-Lo' Adjustment on the 24VF's gas valve, show raising
the flame height.
Part No. XG0138
Maintenance
CAUTIONS
Fireplace gas control must be in the "OFF" position and
pilot and main burners extinguished when cleaning ap-
pliance with a vacuum.
Doors and logs can get very hot. Handle only when
General
Have the fireplace installation inspected and serviced yearly,
including a visual check of the burner and the pilot flame. For your
convenience a 1/8" manifold pressure tap is supplied on the gas
valve for a test gauge connection. See Figure 10.
For Propane Gas this appliance requires a minimum inlet pres-
sure of 35 mbar W.C. and a manifold pressure of 10" W.C.
Always keep the fireplace area clear and free of combustible
materials, as well as gasoline and other flammable vapours and
liquids.
Do not use this appliance if any part has been under water. Imme-
diately call a qualified service technician to inspect the appliance
and to replace any part of the control system and any gas control
which has been under water.
Cleaning
When the fireplace is first activated, there may be some smoking.
This is a normal condition, and is the result of burning of protective
coatings on new metal.
Use a vacuum cleaner or whisk broom to keep the control com-
partment, burner, and firebox free from dust and lint.
Logs may be cleaned periodically with a vacuum to remove soot
or other contaminates.
WARNING:
Do not attempt to clean the fireplace when hot.
24VF Gas Fireplace
Page
Advertisement
Table of Contents
