Daikin FTXR28EV1B Installation Manual page 12

6.
Wiring.
1) Strip wire ends (15mm).
2) Match wire colours with terminal numbers on indoor and outdoor unit's terminal blocks and firmly screw wires to the
corresponding terminals.
3) Connect the earth wires to the corresponding terminals.
4) Pull wires to make sure that they are securely latched up, then retain wires with wire retainer.
5) In case of connecting to an adapter system. Run the remote control cable and attach the S21.
(Refer to 7. Connecting to the HA system.)
6) Shape the wires so that the service lid fits securely, then close service lid.
WARNING
1) Do not use tapped wires, strand wires, extensioncords, or starburst connections, as they may cause overheating, electrical
shock, or fire.
2) Do not use locally purchased electrical parts inside the product. (Do not branch the power for the drain pump, etc., from the
terminal block.) Doing so may cause electric shock or fire.
7.
Connecting to the HA system.
1) Remove the front grille. (3 screws)
2) Remove the decelerator assembly parts.
(1 screw)
2-1) Remove the decelerator assembly
part screws. (See Fig. 1)
2-2) Remove the decelerator assembly
part connector. Remove by pressing
on the tabs on the bottom of the
connector.
(See the tab position diagram 1)
3) Remove the electric parts box.
(1 screw, 2 tabs)
3-1) Remove the electric parts box fixing
screw.
3-2) Pull the electric parts box toward
you and discharge the tab2.
■English
Terminal block
Electrical component box
Shape wires so
that the service
lid will fit securely.
Firmly secure wire retainer
so that wires sustain no
Use the external stress.
specified
Wire retainer
wire type.
Fig. 1
Anti-drip cover
fixing screw
Anti-drip cover
Decelerator assembly
part fixing screw
Electric parts box
fixing screw
Firmly fix the wires with
the terminal screws.
When wire length exceeds
10m, use 2.0mm diameter wires.
1
Indoor
2
3
unit
Firmly fix the wires with
the terminal screws.
Position of tabs on the decelerator
assembly part connector
Tab
Outdoor unit
1 2 3 L N
H05VV
Location of the tabs
on the electric parts box
Tab 2
Tab 1
Buzzer
10