Silicon Graphics Octane R12000 Installation Manual page 15

Silicon Graphics
Replacing the System Module
1. Remove the caps on the compression connectors on the back of the system module.
Do not touch the system module compression connectors as you lift the module into
the workstation.
Caution: Do not insert the system module into the workstation unless the power
cord is unplugged from the electrical socket. Inserting the system module with the
power cord connected to the electrical socket causes damage to the workstation.
2. Grasp the system module by its immovable handle and support it with one hand as
you slide it into the chassis.
3. Push the module completely into the chassis using the immovable handle. (Both
sliding handles protrude.) The system module stops when it is slightly out of the
chassis.
4. Push the sliding handles simultaneously to connect the system module to the
workstation. Push firmly on the handles to completely lock the system module to
the workstation.
The sliding handles are completely recessed and the system module is flush with
the chassis when it is fully seated and locked to the workstation.
5. Tighten the captive screws in the sliding handles to attach the system module to the
chassis.
6. Remove the wrist strap.
7. Replace any cables you removed and plug in the power cord.
Powering On Your Workstation
1. Push the power button on your workstation, then press the power switch on your
monitor.
2. Replace the lockbar.
• Open the cover on the front of your workstation.
• Slide the lockbar into the lockbar slot.
• Insert the lock through the lockbar at the back of your workstation.
Your 2 GB DIMM upgrade is complete!
® OCTANE ® R12000 ™ 2 GB Memory Upgrade Kit Installation Guide
15