2D -54
BODY
REAR DOOR HINGE STRAP
Replacement
1. Remove strap release pin. See figure 2D-127.
2. Remove screws retaining strap to door.
3. Install strap to door. Torque retaining screws to
specifications.
Fig. 2D-1 2 6 -C h e ck in g Assem bly of Hinge
REAR DOORS
REAR DOOR HINGE
Removal
are removed door weight will be on support.
2. Remove hinge strap release pin.
assembly.
4. Remove hinge-to-body bolts and hinge.
Installation
removed).
removed).
retainer and snug bolts.
REAR DOOR REMOTE CONTROL
Removal
by remmoving retaining clips. See figure 2D-128.
screws.
Installation
this position while torquing the screws to specifications.
1. Open door. Support door so that when hinge screws
3. Remove hinge-to-door bolts and remove door
1. Install grommet into door hinge opening (if
2. Install hinge into door. Snug bolts.
3. Install seal and retainer on body half of hinge (if
4. Install hinge into body opening and install bolts.
5. Take care to compress seal between body and
6. Install hinge strap and its retaining pin.
7. Adjust door and torque hinge bolts to specification.
1. Remove trim panel.
2. Disengage upper and lower latch rods from control
3. Remove remote control by removing its retaining
1. Install remote control screws loosely.
2. Attach upper and lower control rods.
3. Rotate remote control lever clockwise, and hold in
4. Install the trim panel.
LIG H T T R U C K S ER V IC E M AN UAL