Medema Mini Crosser M2 User Manual page 47

Medema Production A/S
User guide P9-0157-B
Problem
The "ready" lamp on the
charger lights up even
when partly discharged
batteries are connected.
The charger lamp is
showing an error.
Thermometer symbol is
half-red and fl ashes. The
scooter is running at half
speed.
Thermometer symbol is
red and illuminated. The
scooter has stopped.
Mini Crosser can not
remember the time.
Possible causes
The fuse in the charger
has blown.
The switch in the charging
plug is malfunctioning.
The charging plug has not
been inserted or there is a
mains fault.
The battery voltage is too
low for charging to start.
The motor is overheating
and has reached the limit
of when the fi rst safety
switch responds.
The motor is overheating
and has reached the limit
for when the security
switch shuts the motor off
completely.
Battery on main circuit
board has run out of
power.
47 of 56
Remedy
Contact supplier.
Contact suppliers - read
the operating instructions
for the charger.
Push the charger plug in or
contact the supplier.
Read the operating
instructions for the charger
- or contact the supplier.
Immediately pull over
at a safe distance from
other traffi c and stop the
Mini Crosser. Wait until
the temperature icon
disappears, ca. 3-5 min.
Turn the Mini Crosser off
and on again to continue at
full speed.
If the Mini Crosser has
stopped at an inappropriate
place in traffi c, turn on
the emergency lights.
If possible disengage
the scooter and push
it away from traffi c. Let
Mini Crosser cool until
the temperature icon
disappears - approx. 3-5
min. Turn the Mini Crosser
off and on again. Now it
can run normally again.
Contact service technician.
Version 2.0.3/2012