Recording A Cd: Selecting Tape Length ( Tape Select Edit); Recording A Cd: Specifying Tape Length (Time Edit) - Sony LBT-N455KRW Operating Instructions Manual

Recording a CD:
Selecting Tape
Length (tape select
edit )
You can have the stereo system select and
indicate the most suitable tape length for
recording each disc automatically.
You cannot use tape select edit for discs
which contain 21 tracks or more.
SYSTEM
POWER ON
EN
16
1 π
CHECK
1
1
Press FUNCTION repeatedly until
"CD" appears in the display.
2
Press § OPEN and place a CD on the
tray.
Make sure the disc number in the
playing position in the display is the one
you want to record.
The total number of tracks and the
playing time appear in the display.
Chapter 4: the Tape Player
3
Press EDIT on the remote.
"TAPE SELECT" appears in the display
and the player divides the selections
automatically.
Then the display changes as follows:
CLIP
CLIP
4
Press § EJECT and insert a blank tape
of the indicated length (or longer) into
7
deck B with the side you want to record
on facing forward.
6
Make sure the tabs on the cassette have
5
not been removed.
5
Select dual or single-sided recording.
4
To record
One side of the tape
2
CONTINUE
Both sides*
* Recording always stops at the end of the
reverse side. Be sure to start from the
front side.
6
Press CD SYNCHRO.
The REC and ∏ (pause) lamps light up
3
and deck B stands by for recording.
The · lamp lights up and the ª lamp
flashes for a few seconds, then
disappears.
If you want to start recording from the
reverse side, press ª so that the ª
indicator lights steadily.
7
Press ∏ on the tape player to release
recording pause.
Recording starts.
After about 10 seconds, the CD player
starts playing.
To stop recording
Press π on the tape player.
To check the order
Press CHECK on the remote.
To cancel tape select edit
Press CONTINUE on the unit.
CD
1 2 3 4 5
VOLUME
6 7 8 9 10
11 12 13 14 15
63 125 250 500 1k 2k 4k 8k 16k
(Hz)
16 17 18 19 20
DISC PROGRAM
CD
1 2 3 4 5
VOLUME
6 7 8 9 10
11 12 13 14 15
63 125 250 500 1k 2k
16 17 18 19 20
DISC PROGRAM
flashing
Press DIRECTION
to select
A
ß or RELAY
Side in recording
pause mode
Recording a CD:
Specifying Tape
Length (time edit)
You can have the stereo system create
programmes based on the tape length.
The CD player makes programmes that will
fit the tape length. For example, if you use a
46-minute tape to record a 50-minute CD,
the CD player will automatically choose
tracks that will fit within the 46-minutes,
filling as much of the tape as possible. The
player will not programme those tracks
beyond track number 20.
Use the buttons on both the unit and the
remote to do this operation.
SYSTEM
POWER ON
π
1 2
CONTINUE
CHECK
1
Press FUNCTION repeatedly until
"CD" appears in the display.
2
Press § OPEN and place a CD on the
tray.
Make sure the disc number in the
playing position in the display is the one
you want to record.
The total number of tracks and the
playing time appear in the display.
10
9
4
3
6
5,7,8