Chevrolet Light Duty Truck 1973 Service Manual page 235

Fig. 26—Trunnion Seal Installer
Fig. 27—Propeller Shaft, Universal Joint and Bearing Support
REAR S U S PEN SIO N A N D DRIVELINE
CENTER SUPPORT BEARING—FIG. 27
CAUTION:
See CAUTION on page 1 of t h i s
section regarding Center Support Bearing
fasteners.
1. Remove dust shield.
2. Remove strap retaining rubber cushion from
bearing support.
3. Pull support bracket from rubber cushion and pull
cushion from bearing.
4. Pull bearing assembly from shaft.
5. Assemble bearing support as follows:
a. Install inner deflector on propeller shaft, if
removed, and prick punch deflector at two
opposite points to make sure it is tight on shaft.
b. Fill space between inner dust shield and bearing
with lithium soap grease.
4-11
LIGHT DUTY TRUCK SERVICE MANUAL