Table of Contents
Advertisement
28
EN
Setting Of The Colour System Select Buttons
COLOUR SYSTEM
* "NTSC[PAL" appears during playback only.
Off-Air Recording
The built-in multi-system tuner is capable of receiving PAL B/G, I and D/K, and SECAM B/G and D/K broadcasts.
TV system
PAL B/G, I, D/K
SECAM B/G,
D/K (OIRT)
NOTE:
This model does not operate in BRAZIL (PAL-M) or ARGENTINA (PAL-N).
INFORMATION ON MULTI-SYSTEM COMPATIBILITY
Mode Display
AUTO
NTSC 3.58
NTSC 4.43
NTSC PAL*
PAL
MESECAM
Multi-system
tuner
(B/G, I, D/K)
Use the COLOUR SYSTEM button on the front panel to select
the colour system. Pressing this button changes the mode as
illustrated on the left. The On-Screen display will show which
mode is selected.
Mode
AUTO
Usually set to this mode. This mode
automatically detects PAL, NTSC,
MESECAM and adjusts to the colour system
being recorded or played back.
When it does not perform properly, set the
colour system manually.
MANUAL
For recording, there is a choice of 4
selectable modes; PAL/MESECAM/NTSC
3.58/NTSC4.43. Select the mode that
matches the colour signal being received.
For playback, there is an additional mode
which allows NTSC tapes to be played
back and viewed on PAL TVs.
NOTES:
In the AUTO mode, NTSC signals will be automatically
recorded as NTSC 3.58.
In the AUTO mode, NTSC tapes will be played back as NTSC
3.58.
SECAM signals will always be recorded as MESECAM. Select
the AUTO or the MESECAM mode when recording SECAM
signals.
When playing back a SECAM tape, select the AUTO or
MESECAM mode. The playback picture will always be
monochrome.
In the NTSC4.43 mode, with some TVs, on-screen displays
(Program screen etc.) may roll up or down and there may be a
loss of colour. When this happens, select the AUTO mode.
HR-J461MS
Recording circuit
PAL
MESECAM
Description
Recorded tape
PAL
MESECAM
Advertisement
Table of Contents
