Multiblitz Profilux plus 200 Ws User Manual page 8

EN
USER'S GUIDE.
IR/Photo
Slave cell
Output Setting
Radio trigger
channel selection / ID selection
Test button
Activates radio trigger
Beep/Lamp
Ready indicator
ID activation for radio trigger
Sync Socket
Connector/Antenna
of radio receiver
IMPORTANT INFORMATION!
1. Read the Multiblitz Propac „Quick Start Guide" thoroughly before operating
a Profilux Plus unit with a Propac battery pack.
2. A halogen tube (for 100-130 V or 220-240 V) is included in the scope of delivery.
To ensure a correct color temperature of the modeling light, we recommend to use
the appropriate halogen tube for mains or battery voltage (see below). Halogen
tubes, if not included in the scope of delivery, are available from your Multiblitz
distributor.
Operation with 220-240 V mains voltage:
Profilux Plus 200, 70 W halogen tube (Code: PROHAL)
Profilux Plus 400, 150 W halogen tube (Code: LUHAL 2)
Profilux Plus 800, 205 W halogen tube (Code: LUHAL 3)
Operation with 100-130 V mains voltage/
Battery operation (see „Propac Quick Start Guide"):
150 W halogen tube (Code: PACHAL)
Pyrex-Dome (Code: PLUSKLA)
3. It is absolutely necessary to exchange the halogen tube when switching from
battery operation to 220–240 V mains operation and from 100-130 V mains
operation to 220–240 V mains operation.
8
100-130 V mains operation to 220-240 V mains operation:
Exchange the 100 V–130 V halogen tube PACHAL with the 220–240 V
tubes PROHAL, LUHAL 2 or LUHAL 3.
Battery operation with Propac-1 or -2 to 220-240 V mains operation:
Exchange the 100 V–130 V halogen tube PACHAL with the 220–240 V
tubes PROHAL, LUHAL 2 or LUHAL 3.
It is not necessary to exchange halogen tubes when switching from battery opera-
tion with a Propac 1 or Propac 2 to 100-130 V mains operation and vice versa.
The recommended tube for battery operation and 100- 130 V mains operation
(Code: PACHAL) is designated for both operating modes.
4. The modeling light can be used during battery operation. To conserve
battery power the modeling light turns off automatically after 15 sec.
if no flash is fired, during that time the „Modeling Light On-Off" button blinks
(the „Modeling Light 100 %" button as well, if switched on). As soon as a flash
is fired the modeling light turns on again and the „Modeling Light On-Off" button
glows permanently.
Display
Radio receiver „active" indication
Indication CH/ ID (radio trigger)
IR/Photo Slave Cell
On-Off
Activates
Pre-Flash Eliminator,
Pre-Flash Eliminator
„active" indication
Power On-Off
Modeling Lamp On
(prop x)-Off
Modeling Light
„Auto-Off" indication
Modeling Lamp
100% On-Off
Modeling Light
„Auto-Off" indication
Fuse holder/
Spare fuse