Index Search; Repeat Playback - JVC HR-J261MS Instructions Manual

14
EN
2
REW
STOP
MENU
3
OK
1
1 2 3
4 5 6
7 8 9
0
4
TIMER
FF
PAUSE
PUSH JOG

Index Search

Your recorder automatically marks
index codes at the beginning of
each recording. This function gives
you quick access to any one of 9
index codes in either direction.
NOTE:
Before starting, make sure the
recorder is in the Stop mode.
ACTIVATE INDEX SEARCH
1
Press PUSH JOG
control. "™ 1" or "£ 1" is displayed on screen and
search begins in the corresponding direction.
To access index codes 2 through 9, press PUSH JOG
or repeatedly until the correct index number is
displayed.
Ex.: To locate the beginning of B from the current
position, press PUSH JOG twice.
To locate the beginning of D from the current
position, press PUSH JOG
A
–2
When the specified index code is located, playback
begins automatically.

Repeat Playback

Your video recorder can automatically play back the whole tape
50 times repeatedly.
START PLAYBACK
1
Press PLAY.
ACTIVATE REPEAT
PLAYBACK
2
Press PLAY and hold for over 5 seconds, then release.
The Play indicator ( ) on the display panel blinks
slowly.
The tape plays 50 times automatically, and then
stops.
STOP PLAYBACK
3
Press STOP at any time to stop playback.
NOTE:
Pressing PLAY, REW, FF or PAUSE also stops Repeat Playback.
PLAYBACK (cont.)
or (™ or £) on the remote
once.
Current position
B C D E F
–1 1 2 3
Index number
£ 2